pinctrl/amd: Configure GPIO register using BIOS settings
In the function amd_gpio_irq_set_type, use the settings provided by
the BIOS,when the LevelTrig is Edge and activeLevel is HIGH, to configure
the GPIO registers. Ignore the settings from client.
Reviewed-by: Pankaj Sen <Pankaj.Sen@amd.com>
Signed-off-by:Nitesh Kumar Agrawal <Nitesh-kumar.Agrawal@amd.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/pinctrl/pinctrl-amd.c b/drivers/pinctrl/pinctrl-amd.c
index 634b4d3..962746e 100644
--- a/drivers/pinctrl/pinctrl-amd.c
+++ b/drivers/pinctrl/pinctrl-amd.c
@@ -403,12 +403,27 @@
int ret = 0;
u32 pin_reg;
unsigned long flags;
+ u32 level_trig;
+ u32 active_level;
struct gpio_chip *gc = irq_data_get_irq_chip_data(d);
struct amd_gpio *gpio_dev = gpiochip_get_data(gc);
spin_lock_irqsave(&gpio_dev->lock, flags);
pin_reg = readl(gpio_dev->base + (d->hwirq)*4);
+ /*
+ * When level_trig is set EDGE and active_level is set HIGH in BIOS
+ * default settings, ignore incoming settings from client and use
+ * BIOS settings to configure GPIO register.
+ */
+ level_trig = pin_reg & (LEVEL_TRIGGER << LEVEL_TRIG_OFF);
+ active_level = pin_reg & (ACTIVE_LEVEL_MASK << ACTIVE_LEVEL_OFF);
+
+ if((!level_trig) &&
+ ((active_level >> ACTIVE_LEVEL_OFF) == ACTIVE_HIGH)) {
+ type = IRQ_TYPE_EDGE_FALLING;
+ }
+
switch (type & IRQ_TYPE_SENSE_MASK) {
case IRQ_TYPE_EDGE_RISING:
pin_reg &= ~BIT(LEVEL_TRIG_OFF);