pinctrl: baytrail: Do not add all GPIOs to IRQ domain
When DIRECT_IRQ_EN is set, the pin is routed directly to the IO-APIC bypassing
the GPIO driver completely. However, the mask register is still used to
determine if the pin is supposed to generate IRQ or not.
So with commit 3ae02c14d964 the IRQ core masks all IRQs (because of
handle_bad_irq()) the pin connected to the touchscreen gets masked as well and
hence no interrupts.
To make this all work as expected we do not add those GPIOs to the IRQ domain
that can actually propagate interrupts.
Fixes: 3ae02c14d964 ("pinctrl: intel: set default handler to be handle_bad_irq()")
Reported-by: Robert R. Howell <rhowell@uwyo.edu>
Suggested-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/pinctrl/intel/pinctrl-baytrail.c b/drivers/pinctrl/intel/pinctrl-baytrail.c
index 67e9269..c123488 100644
--- a/drivers/pinctrl/intel/pinctrl-baytrail.c
+++ b/drivers/pinctrl/intel/pinctrl-baytrail.c
@@ -1623,6 +1623,8 @@
static void byt_gpio_irq_init_hw(struct byt_gpio *vg)
{
+ struct gpio_chip *gc = &vg->chip;
+ struct device *dev = &vg->pdev->dev;
void __iomem *reg;
u32 base, value;
int i;
@@ -1644,10 +1646,12 @@
}
value = readl(reg);
- if ((value & BYT_PIN_MUX) == byt_get_gpio_mux(vg, i) &&
- !(value & BYT_DIRECT_IRQ_EN)) {
+ if (value & BYT_DIRECT_IRQ_EN) {
+ clear_bit(i, gc->irq_valid_mask);
+ dev_dbg(dev, "excluding GPIO %d from IRQ domain\n", i);
+ } else if ((value & BYT_PIN_MUX) == byt_get_gpio_mux(vg, i)) {
byt_gpio_clear_triggering(vg, i);
- dev_dbg(&vg->pdev->dev, "disabling GPIO %d\n", i);
+ dev_dbg(dev, "disabling GPIO %d\n", i);
}
}
@@ -1686,6 +1690,7 @@
gc->can_sleep = false;
gc->parent = &vg->pdev->dev;
gc->ngpio = vg->soc_data->npins;
+ gc->irq_need_valid_mask = true;
#ifdef CONFIG_PM_SLEEP
vg->saved_context = devm_kcalloc(&vg->pdev->dev, gc->ngpio,