libata: ahci enclosure management bios workaround
During driver initialization ahci_start_port may not be able
to turn LEDs off because the hardware may still be transmitting
a message. And since the BIOS may not be setting the LEDs to
off the drive LEDs may end up in a fault state. This has
been seen on ICH9r and ICH10r when configured in AHCI mode
instead of RAID mode, this patch doesn't key off a specific
set of device IDs but will give the EM transmit bit a chance
to clear if busy.
Signed-off-by: David Milburn <dmilburn@redhat.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c
index 788bba2..6ca4bc0 100644
--- a/drivers/ata/ahci.c
+++ b/drivers/ata/ahci.c
@@ -78,6 +78,7 @@
static ssize_t ahci_transmit_led_message(struct ata_port *ap, u32 state,
ssize_t size);
#define MAX_SLOTS 8
+#define MAX_RETRY 15
enum {
AHCI_PCI_BAR = 5,
@@ -1115,6 +1116,8 @@
struct ahci_port_priv *pp = ap->private_data;
struct ata_link *link;
struct ahci_em_priv *emp;
+ ssize_t rc;
+ int i;
/* enable FIS reception */
ahci_start_fis_rx(ap);
@@ -1126,7 +1129,17 @@
if (ap->flags & ATA_FLAG_EM) {
ata_for_each_link(link, ap, EDGE) {
emp = &pp->em_priv[link->pmp];
- ahci_transmit_led_message(ap, emp->led_state, 4);
+
+ /* EM Transmit bit maybe busy during init */
+ for (i = 0; i < MAX_RETRY; i++) {
+ rc = ahci_transmit_led_message(ap,
+ emp->led_state,
+ 4);
+ if (rc == -EBUSY)
+ udelay(100);
+ else
+ break;
+ }
}
}
@@ -1331,7 +1344,7 @@
em_ctl = readl(mmio + HOST_EM_CTL);
if (em_ctl & EM_CTL_TM) {
spin_unlock_irqrestore(ap->lock, flags);
- return -EINVAL;
+ return -EBUSY;
}
/*