Blackfin: bf561-ezkit: change parallel flash from M to Y in defconfig
These flashes are always on the board, so might as well enable them by
default rather than a module.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/arch/blackfin/configs/BF561-EZKIT_defconfig b/arch/blackfin/configs/BF561-EZKIT_defconfig
index 1c0a82a..d7ff2ae 100644
--- a/arch/blackfin/configs/BF561-EZKIT_defconfig
+++ b/arch/blackfin/configs/BF561-EZKIT_defconfig
@@ -58,13 +58,13 @@
CONFIG_MTD=y
CONFIG_MTD_PARTITIONS=y
CONFIG_MTD_CMDLINE_PARTS=y
-CONFIG_MTD_CHAR=m
+CONFIG_MTD_CHAR=y
CONFIG_MTD_BLOCK=y
-CONFIG_MTD_CFI=m
-CONFIG_MTD_CFI_AMDSTD=m
+CONFIG_MTD_CFI=y
+CONFIG_MTD_CFI_AMDSTD=y
CONFIG_MTD_RAM=y
CONFIG_MTD_ROM=m
-CONFIG_MTD_PHYSMAP=m
+CONFIG_MTD_PHYSMAP=y
CONFIG_BLK_DEV_RAM=y
CONFIG_NETDEVICES=y
CONFIG_NET_ETHERNET=y