tree c7828d2df441bb5dfa75f143184399e25cfcc3c2
parent 60a93cffcffdc86222c184aafc622b53b8460427
author Johan Hovold <johan@kernel.org> 1496764740 +0200
committer Greg Kroah-Hartman <gregkh@linuxfoundation.org> 1497344852 +0200

driver core: add helper to reuse a device-tree node

Add a helper function to be used when reusing the device-tree node of
another device.

It is fairly common for drivers to reuse the device-tree node of a
parent (or other ancestor) device when creating class or bus devices
(e.g. gpio chips, i2c adapters, iio chips, spi masters, serdev, phys,
usb root hubs). But reusing a device-tree node may cause problems if the
new device is later probed as for example driver core would currently
attempt to reinitialise an already active associated pinmux
configuration.

Other potential issues include the platform-bus code unconditionally
dropping the device-tree node reference in its device destructor,
reinitialisation of other bus-managed resources such as clocks, and the
recently added DMA-setup in driver core.

Note that for most examples above this is currently not an issue as the
devices are never probed, but this is a problem for the USB bus which
has recently gained device-tree support. This was discovered and
worked-around in a rather ad-hoc fashion by commit dc5878abf49c ("usb:
core: move root hub's device node assignment after it is added to bus")
by not setting the of_node pointer until after the root-hub device has
been registered.

Instead we can allow devices to reuse a device-tree node by setting a
flag in their struct device that can be used by core, bus and driver
code to avoid resources from being over-allocated.

Note that the helper also grabs an extra reference to the device node,
which specifically balances the unconditional put in the platform-device
destructor.

Signed-off-by: Johan Hovold <johan@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>