Blackfin arch: add error message when IRQ no available
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
diff --git a/arch/blackfin/mach-common/ints-priority-sc.c b/arch/blackfin/mach-common/ints-priority-sc.c
index 3f6305d..4708023f 100644
--- a/arch/blackfin/mach-common/ints-priority-sc.c
+++ b/arch/blackfin/mach-common/ints-priority-sc.c
@@ -579,8 +579,12 @@
u16 gpionr = irq - IRQ_PA0;
u8 pint_val = irq2pint_lut[irq - SYS_IRQS];
- if (pint_val == IRQ_NOT_AVAIL)
+ if (pint_val == IRQ_NOT_AVAIL) {
+ printk(KERN_ERR
+ "GPIO IRQ %d :Not in PINT Assign table "
+ "Reconfigure Interrupt to Port Assignemt\n", irq);
return -ENODEV;
+ }
if (!(gpio_enabled[gpio_bank(gpionr)] & gpio_bit(gpionr))) {
ret = gpio_request(gpionr, NULL);