iwlwifi: mvm: call ieee80211_scan_completed() even if scan abort fails
A scan abort command failure is not that unusual, since we may try to
send it after the scan has actually completed but before we received
the completed notification from the firmware. The scan abort can also
fail for other reasons, such as a timeout. In such cases, we should
clear things up so the next scans will work again. To do so, don't
return immediately in case of failures, but call
ieee80211_scan_completed() and clear the scan_status flags.
Signed-off-by: Luciano Coelho <luciano.coelho@intel.com>
Reviewed-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/mvm/scan.c b/drivers/net/wireless/iwlwifi/mvm/scan.c
index 7e9aa3c..c47c8051 100644
--- a/drivers/net/wireless/iwlwifi/mvm/scan.c
+++ b/drivers/net/wireless/iwlwifi/mvm/scan.c
@@ -1128,8 +1128,10 @@
if (mvm->scan_status == IWL_MVM_SCAN_NONE)
return 0;
- if (iwl_mvm_is_radio_killed(mvm))
+ if (iwl_mvm_is_radio_killed(mvm)) {
+ ret = 0;
goto out;
+ }
if (mvm->scan_status != IWL_MVM_SCAN_SCHED &&
(!(mvm->fw->ucode_capa.api[0] & IWL_UCODE_TLV_API_LMAC_SCAN) ||
@@ -1148,16 +1150,14 @@
IWL_DEBUG_SCAN(mvm, "Send stop %sscan failed %d\n",
sched ? "offloaded " : "", ret);
iwl_remove_notification(&mvm->notif_wait, &wait_scan_done);
- return ret;
+ goto out;
}
IWL_DEBUG_SCAN(mvm, "Successfully sent stop %sscan\n",
sched ? "offloaded " : "");
ret = iwl_wait_notification(&mvm->notif_wait, &wait_scan_done, 1 * HZ);
- if (ret)
- return ret;
-
+out:
/*
* Clear the scan status so the next scan requests will succeed. This
* also ensures the Rx handler doesn't do anything, as the scan was
@@ -1167,7 +1167,6 @@
if (mvm->scan_status == IWL_MVM_SCAN_OS)
iwl_mvm_unref(mvm, IWL_MVM_REF_SCAN);
-out:
mvm->scan_status = IWL_MVM_SCAN_NONE;
if (notify) {
@@ -1177,7 +1176,7 @@
ieee80211_scan_completed(mvm->hw, true);
}
- return 0;
+ return ret;
}
static void iwl_mvm_unified_scan_fill_tx_cmd(struct iwl_mvm *mvm,