stmmac: never check EEE in case of a switch is attached
This patch is to skip the EEE initialisation when the stmmac
is using a switch (with a fixed phy support).
Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index df15f00..3b8b57e 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -275,6 +275,7 @@
*/
bool stmmac_eee_init(struct stmmac_priv *priv)
{
+ char *phy_bus_name = priv->plat->phy_bus_name;
bool ret = false;
/* Using PCS we cannot dial with the phy registers at this stage
@@ -284,6 +285,10 @@
(priv->pcs == STMMAC_PCS_RTBI))
goto out;
+ /* Never init EEE in case of a switch is attached */
+ if (phy_bus_name && (!strcmp(phy_bus_name, "fixed")))
+ goto out;
+
/* MAC core supports the EEE feature. */
if (priv->dma_cap.eee) {
int tx_lpi_timer = priv->tx_lpi_timer;