V4L/DVB (8031): Anysee: support for Anysee E30C Plus rev 0.4
- support for Anysee E30C Plus rev 0.4
- set IO port E
- set correct TS mode
- change deltaf according to latest Windows driver
Signed-off-by: Antti Palosaari <crope@iki.fi>
Signed-off-by: Mauro Carvalho Chehab <mchehab@infradead.org>
diff --git a/drivers/media/dvb/dvb-usb/anysee.c b/drivers/media/dvb/dvb-usb/anysee.c
index dada92a..a3f9bbc 100644
--- a/drivers/media/dvb/dvb-usb/anysee.c
+++ b/drivers/media/dvb/dvb-usb/anysee.c
@@ -227,7 +227,8 @@
.pll_m = 11,
.pll_p = 3,
.pll_n = 1,
- .deltaf = 0xfed6,
+ .output_mode = TDA10023_OUTPUT_MODE_PARALLEL_C,
+ .deltaf = 0xfeeb,
};
static struct mt352_config anysee_mt352_config = {
@@ -272,8 +273,8 @@
1. E30 MT352 02 0.2.1
2. E30 ZL10353 02 0.2.1
3. E30 Plus ZL10353 06 0.1.0
- 4. E30C Plus TDA10023 0a 0.1.0
- E30C Plus TDA10023 0f 0.1.2 (not working)
+ 4. E30C Plus TDA10023 0a 0.1.0 rev 0.2
+ 4. E30C Plus TDA10023 0f 0.1.2 rev 0.4
*/
/* Zarlink MT352 DVB-T demod inside of Samsung DNOS404ZH102A NIM */
@@ -305,13 +306,10 @@
return 0;
}
- /* known not working (E30C Plus v0.1.2) */
- if (hw_info[0] == 0x0f) {
- info("this version of Anysee is not supported yet");
- /* return IO port D to init value for safe */
- ret = anysee_write_reg(adap->dev, 0xb0, io_d);
- return -ENODEV;
- }
+ /* IO port E - E30C rev 0.4 board requires this */
+ ret = anysee_write_reg(adap->dev, 0xb1, 0xa7);
+ if (ret)
+ return ret;
/* Philips TDA10023 DVB-C demod */
adap->fe = dvb_attach(tda10023_attach, &anysee_tda10023_config,