ARM: netx: stop using mach/timex.h
mach/timex.h is the last remaining header that is unused for multiarch
builds but necessary for singlearch builds. To allow to get rid of it
for singlearch builds, too, drop its usage in netx arch code by
substituting CLOCK_TICK_RATE and LATCH by a local cpp symbol.
Acked-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
diff --git a/arch/arm/mach-netx/time.c b/arch/arm/mach-netx/time.c
index 6df42e6..e234601 100644
--- a/arch/arm/mach-netx/time.c
+++ b/arch/arm/mach-netx/time.c
@@ -28,6 +28,9 @@
#include <asm/mach/time.h>
#include <mach/netx-regs.h>
+#define NETX_CLOCK_FREQ 100000000
+#define NETX_LATCH DIV_ROUND_CLOSEST(NETX_CLOCK_FREQ, HZ)
+
#define TIMER_CLOCKEVENT 0
#define TIMER_CLOCKSOURCE 1
@@ -41,7 +44,7 @@
switch (mode) {
case CLOCK_EVT_MODE_PERIODIC:
- writel(LATCH, NETX_GPIO_COUNTER_MAX(TIMER_CLOCKEVENT));
+ writel(NETX_LATCH, NETX_GPIO_COUNTER_MAX(TIMER_CLOCKEVENT));
tmode = NETX_GPIO_COUNTER_CTRL_RST_EN |
NETX_GPIO_COUNTER_CTRL_IRQ_EN |
NETX_GPIO_COUNTER_CTRL_RUN;
@@ -114,7 +117,7 @@
/* Reset the timer value to zero */
writel(0, NETX_GPIO_COUNTER_CURRENT(0));
- writel(LATCH, NETX_GPIO_COUNTER_MAX(0));
+ writel(NETX_LATCH, NETX_GPIO_COUNTER_MAX(0));
/* acknowledge interrupt */
writel(COUNTER_BIT(0), NETX_GPIO_IRQ);
@@ -137,11 +140,11 @@
NETX_GPIO_COUNTER_CTRL(TIMER_CLOCKSOURCE));
clocksource_mmio_init(NETX_GPIO_COUNTER_CURRENT(TIMER_CLOCKSOURCE),
- "netx_timer", CLOCK_TICK_RATE, 200, 32, clocksource_mmio_readl_up);
+ "netx_timer", NETX_CLOCK_FREQ, 200, 32, clocksource_mmio_readl_up);
/* with max_delta_ns >= delta2ns(0x800) the system currently runs fine.
* Adding some safety ... */
netx_clockevent.cpumask = cpumask_of(0);
- clockevents_config_and_register(&netx_clockevent, CLOCK_TICK_RATE,
+ clockevents_config_and_register(&netx_clockevent, NETX_CLOCK_FREQ,
0xa00, 0xfffffffe);
}