[SCSI] qla4xxx: Correct early completion of pending mbox.
Check for Firmware Hang (AF_FW_RECOVERY) after mailbox command
has gained access to ensure that the mailbox command does not
wait un-necessarily during a firmware recovery and prevent
premature mailbox timeout which will lead to back to back reset's.
Signed-off-by: Lalit Chandivade <lalit.chandivade@qlogic.com>
Signed-off-by: Vikas Chaudhary <vikas.chaudhary@qlogic.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/qla4xxx/ql4_mbx.c b/drivers/scsi/qla4xxx/ql4_mbx.c
index 7ac21da..c7d101e 100644
--- a/drivers/scsi/qla4xxx/ql4_mbx.c
+++ b/drivers/scsi/qla4xxx/ql4_mbx.c
@@ -51,25 +51,6 @@
}
}
- if (is_qla8022(ha)) {
- if (test_bit(AF_FW_RECOVERY, &ha->flags)) {
- DEBUG2(ql4_printk(KERN_WARNING, ha, "scsi%ld: %s: "
- "prematurely completing mbx cmd as firmware "
- "recovery detected\n", ha->host_no, __func__));
- return status;
- }
- /* Do not send any mbx cmd if h/w is in failed state*/
- qla4_8xxx_idc_lock(ha);
- dev_state = qla4_8xxx_rd_32(ha, QLA82XX_CRB_DEV_STATE);
- qla4_8xxx_idc_unlock(ha);
- if (dev_state == QLA82XX_DEV_FAILED) {
- ql4_printk(KERN_WARNING, ha, "scsi%ld: %s: H/W is in "
- "failed state, do not send any mailbox commands\n",
- ha->host_no, __func__);
- return status;
- }
- }
-
if ((is_aer_supported(ha)) &&
(test_bit(AF_PCI_CHANNEL_IO_PERM_FAILURE, &ha->flags))) {
DEBUG2(printk(KERN_WARNING "scsi%ld: %s: Perm failure on EEH, "
@@ -96,6 +77,25 @@
msleep(10);
}
+ if (is_qla8022(ha)) {
+ if (test_bit(AF_FW_RECOVERY, &ha->flags)) {
+ DEBUG2(ql4_printk(KERN_WARNING, ha,
+ "scsi%ld: %s: prematurely completing mbx cmd as firmware recovery detected\n",
+ ha->host_no, __func__));
+ goto mbox_exit;
+ }
+ /* Do not send any mbx cmd if h/w is in failed state*/
+ qla4_8xxx_idc_lock(ha);
+ dev_state = qla4_8xxx_rd_32(ha, QLA82XX_CRB_DEV_STATE);
+ qla4_8xxx_idc_unlock(ha);
+ if (dev_state == QLA82XX_DEV_FAILED) {
+ ql4_printk(KERN_WARNING, ha,
+ "scsi%ld: %s: H/W is in failed state, do not send any mailbox commands\n",
+ ha->host_no, __func__);
+ goto mbox_exit;
+ }
+ }
+
spin_lock_irqsave(&ha->hardware_lock, flags);
ha->mbox_status_count = outCount;