power: bq24257: Remove IRQ config through stat-gpios
At the time the driver was written GpioInt resources in ACPI were not
passed to the driver in client->irq, as opposed to DT enumeration. To
accommodate this use case, a "stat-gpios" property was introduced to
allow configuring the IRQ.
However this issue with ACPI was fixed in commit "845c877 i2c / ACPI:
Assign IRQ for devices that have GpioInt automatically" and makes this
workaround no longer necessary, hence we can remove the support for the
"stat-gpios" property and the associated code from the bq24257 driver.
Signed-off-by: Andreas Dannenberg <dannenberg@ti.com>
Signed-off-by: Sebastian Reichel <sre@kernel.org>
diff --git a/drivers/power/bq24257_charger.c b/drivers/power/bq24257_charger.c
index 5859bc7..69b53d0 100644
--- a/drivers/power/bq24257_charger.c
+++ b/drivers/power/bq24257_charger.c
@@ -36,7 +36,6 @@
#define BQ24257_REG_7 0x06
#define BQ24257_MANUFACTURER "Texas Instruments"
-#define BQ24257_STAT_IRQ "stat"
#define BQ24257_PG_GPIO "pg"
#define BQ24257_ILIM_SET_DELAY 1000 /* msec */
@@ -606,19 +605,6 @@
return 0;
}
-static int bq24257_irq_probe(struct bq24257_device *bq)
-{
- struct gpio_desc *stat_irq;
-
- stat_irq = devm_gpiod_get_index(bq->dev, BQ24257_STAT_IRQ, 0, GPIOD_IN);
- if (IS_ERR(stat_irq)) {
- dev_err(bq->dev, "could not probe stat_irq pin\n");
- return PTR_ERR(stat_irq);
- }
-
- return gpiod_to_irq(stat_irq);
-}
-
static int bq24257_pg_gpio_probe(struct bq24257_device *bq)
{
bq->pg = devm_gpiod_get_index(bq->dev, BQ24257_PG_GPIO, 0, GPIOD_IN);
@@ -740,21 +726,15 @@
return ret;
}
- if (client->irq <= 0)
- client->irq = bq24257_irq_probe(bq);
-
- if (client->irq < 0) {
- dev_err(dev, "no irq resource found\n");
- return client->irq;
- }
-
ret = devm_request_threaded_irq(dev, client->irq, NULL,
bq24257_irq_handler_thread,
IRQF_TRIGGER_FALLING |
IRQF_TRIGGER_RISING | IRQF_ONESHOT,
- BQ24257_STAT_IRQ, bq);
- if (ret)
+ "bq24257", bq);
+ if (ret) {
+ dev_err(dev, "Failed to request IRQ #%d\n", client->irq);
return ret;
+ }
ret = bq24257_power_supply_init(bq);
if (ret < 0)