hwmon: (k8temp) Remove superfluous CPU family check
The family check in k8temp is not required because the driver is
already bound to a northbridge device only used with K8 CPUs.
Signed-off-by: Andreas Herrmann <andreas.herrmann3@amd.com>
Signed-off-by: Jean Delvare <khali@linux-fr.org>
diff --git a/drivers/hwmon/k8temp.c b/drivers/hwmon/k8temp.c
index 39ead2a..418496f 100644
--- a/drivers/hwmon/k8temp.c
+++ b/drivers/hwmon/k8temp.c
@@ -191,38 +191,31 @@
model = boot_cpu_data.x86_model;
stepping = boot_cpu_data.x86_mask;
- switch (boot_cpu_data.x86) {
- case 0xf:
- /* feature available since SH-C0, exclude older revisions */
- if (((model == 4) && (stepping == 0)) ||
- ((model == 5) && (stepping <= 1))) {
- err = -ENODEV;
- goto exit_free;
- }
-
- /*
- * AMD NPT family 0fh, i.e. RevF and RevG:
- * meaning of SEL_CORE bit is inverted
- */
- if (model >= 0x40) {
- data->swap_core_select = 1;
- dev_warn(&pdev->dev, "Temperature readouts might be "
- "wrong - check erratum #141\n");
- }
-
- if (is_rev_g_desktop(model)) {
- /*
- * RevG desktop CPUs (i.e. no socket S1G1 or
- * ASB1 parts) need additional offset,
- * otherwise reported temperature is below
- * ambient temperature
- */
- data->temp_offset = 21000;
- }
-
- break;
+ /* feature available since SH-C0, exclude older revisions */
+ if (((model == 4) && (stepping == 0)) ||
+ ((model == 5) && (stepping <= 1))) {
+ err = -ENODEV;
+ goto exit_free;
}
+ /*
+ * AMD NPT family 0fh, i.e. RevF and RevG:
+ * meaning of SEL_CORE bit is inverted
+ */
+ if (model >= 0x40) {
+ data->swap_core_select = 1;
+ dev_warn(&pdev->dev, "Temperature readouts might be wrong - "
+ "check erratum #141\n");
+ }
+
+ /*
+ * RevG desktop CPUs (i.e. no socket S1G1 or ASB1 parts) need
+ * additional offset, otherwise reported temperature is below
+ * ambient temperature
+ */
+ if (is_rev_g_desktop(model))
+ data->temp_offset = 21000;
+
pci_read_config_byte(pdev, REG_TEMP, &scfg);
scfg &= ~(SEL_PLACE | SEL_CORE); /* Select sensor 0, core0 */
pci_write_config_byte(pdev, REG_TEMP, scfg);