Input: add a driver to support InvenSense mpu3050 gyroscope chip
This driver is registered as an input device. An IRQ is required in this
basic driver configuration.
Signed-off-by: Joseph Lai <joseph_lai@wistron.com>
[Cleaned up PM_RUNTIME defines]
Signed-off-by: Alan Cox <alan@linux.intel.com>
[dtor@mail.ru: consolidated PM methods, some code rearrangement]
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
diff --git a/drivers/input/misc/Kconfig b/drivers/input/misc/Kconfig
index 0f22918..6fdce4b 100644
--- a/drivers/input/misc/Kconfig
+++ b/drivers/input/misc/Kconfig
@@ -111,6 +111,16 @@
To compile this driver as a module, choose M here: the
module will be called mma8450.
+config INPUT_MPU3050
+ tristate "MPU3050 Triaxial gyroscope sensor"
+ depends on I2C
+ help
+ Say Y here if you want to support InvenSense MPU3050
+ connected via an I2C bus.
+
+ To compile this driver as a module, choose M here: the
+ module will be called mpu3050.
+
config INPUT_APANEL
tristate "Fujitsu Lifebook Application Panel buttons"
depends on X86 && I2C && LEDS_CLASS