ARM: at91/boards: use -EINVAL for invalid gpio
this will allow to use gpio_is_valid
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Cc: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-snapper9260.c b/arch/arm/mach-at91/board-snapper9260.c
index 73ed8c7..4770db0 100644
--- a/arch/arm/mach-at91/board-snapper9260.c
+++ b/arch/arm/mach-at91/board-snapper9260.c
@@ -57,15 +57,19 @@
static struct at91_usbh_data __initdata snapper9260_usbh_data = {
.ports = 2,
+ .vbus_pin = {-EINVAL, -EINVAL},
+ .overcurrent_pin= {-EINVAL, -EINVAL},
};
static struct at91_udc_data __initdata snapper9260_udc_data = {
.vbus_pin = SNAPPER9260_IO_EXP_GPIO(5),
.vbus_active_low = 1,
.vbus_polled = 1,
+ .pullup_pin = -EINVAL,
};
static struct macb_platform_data snapper9260_macb_data = {
+ .phy_irq_pin = -EINVAL,
.is_rmii = 1,
};
@@ -104,6 +108,8 @@
.parts = snapper9260_nand_partitions,
.num_parts = ARRAY_SIZE(snapper9260_nand_partitions),
.bus_width_16 = 0,
+ .enable_pin = -EINVAL,
+ .det_pin = -EINVAL,
};
static struct sam9_smc_config __initdata snapper9260_nand_smc_config = {