atmel_spi: label GPIOs better
Make the atmel_spi driver label GPIOs according to the device for which
they're acting as a chipselect. This way the debugfs dump of gpio state is
more informative.
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Cc: Haavard Skinnemoen <hskinnemoen@atmel.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/spi/atmel_spi.c b/drivers/spi/atmel_spi.c
index 0d342dc..ff6a14b 100644
--- a/drivers/spi/atmel_spi.c
+++ b/drivers/spi/atmel_spi.c
@@ -497,7 +497,7 @@
/* chipselect must have been muxed as GPIO (e.g. in board setup) */
npcs_pin = (unsigned int)spi->controller_data;
if (!spi->controller_state) {
- ret = gpio_request(npcs_pin, "spi_npcs");
+ ret = gpio_request(npcs_pin, spi->dev.bus_id);
if (ret)
return ret;
spi->controller_state = (void *)npcs_pin;