e1000e: 82579 PHY incorrectly identified during init
During init, reading the 2 PHY ID registers back-to-back in the default
fast mode could return invalid data (all F's) and in slow mode could
return data to the second read the data from the first read. To resolve
the issue in fast mode, set to slow mode before any PHY accesses; to
resolve the issue in slow mode, put in a delay for every 82579 PHY access.
Since this PHY is currently only paired with the pch2lan MAC and the PHY
type is not known before the first PHY access which can fail this way,
check for this based on MAC-type.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/e1000e/ich8lan.c b/drivers/net/e1000e/ich8lan.c
index d7fc930..5080372 100644
--- a/drivers/net/e1000e/ich8lan.c
+++ b/drivers/net/e1000e/ich8lan.c
@@ -338,12 +338,17 @@
}
phy->id = e1000_phy_unknown;
- ret_val = e1000e_get_phy_id(hw);
- if (ret_val)
- goto out;
- if ((phy->id == 0) || (phy->id == PHY_REVISION_MASK)) {
+ switch (hw->mac.type) {
+ default:
+ ret_val = e1000e_get_phy_id(hw);
+ if (ret_val)
+ goto out;
+ if ((phy->id != 0) && (phy->id != PHY_REVISION_MASK))
+ break;
+ /* fall-through */
+ case e1000_pch2lan:
/*
- * In case the PHY needs to be in mdio slow mode (eg. 82577),
+ * In case the PHY needs to be in mdio slow mode,
* set slow mode and try to get the PHY id again.
*/
ret_val = e1000_set_mdio_slow_mode_hv(hw);
@@ -352,6 +357,7 @@
ret_val = e1000e_get_phy_id(hw);
if (ret_val)
goto out;
+ break;
}
phy->type = e1000e_get_phy_type_from_id(phy->id);
diff --git a/drivers/net/e1000e/phy.c b/drivers/net/e1000e/phy.c
index 6ad90cc..95da386 100644
--- a/drivers/net/e1000e/phy.c
+++ b/drivers/net/e1000e/phy.c
@@ -226,6 +226,13 @@
}
*data = (u16) mdic;
+ /*
+ * Allow some time after each MDIC transaction to avoid
+ * reading duplicate data in the next MDIC transaction.
+ */
+ if (hw->mac.type == e1000_pch2lan)
+ udelay(100);
+
return 0;
}
@@ -279,6 +286,13 @@
return -E1000_ERR_PHY;
}
+ /*
+ * Allow some time after each MDIC transaction to avoid
+ * reading duplicate data in the next MDIC transaction.
+ */
+ if (hw->mac.type == e1000_pch2lan)
+ udelay(100);
+
return 0;
}