iwlwifi: move 3945 clip groups to 3945 data
Only used on 3945, so it can be in the
3945-specific part of the data.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Reinette Chatre <reinette.chatre@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-3945.c b/drivers/net/wireless/iwlwifi/iwl-3945.c
index 9a5a7b1..ed59e27 100644
--- a/drivers/net/wireless/iwlwifi/iwl-3945.c
+++ b/drivers/net/wireless/iwlwifi/iwl-3945.c
@@ -1607,7 +1607,7 @@
int power;
/* Get this chnlgrp's rate-to-max/clip-powers table */
- clip_pwrs = priv->clip39_groups[ch_info->group_index].clip_powers;
+ clip_pwrs = priv->_3945.clip_groups[ch_info->group_index].clip_powers;
/* Get this channel's rate-to-current-power settings table */
power_info = ch_info->power_info;
@@ -1733,7 +1733,7 @@
}
/* Get this chnlgrp's rate-to-max/clip-powers table */
- clip_pwrs = priv->clip39_groups[ch_info->group_index].clip_powers;
+ clip_pwrs = priv->_3945.clip_groups[ch_info->group_index].clip_powers;
/* set scan tx power, 1Mbit for CCK, 6Mbit for OFDM */
for (scan_tbl_index = 0;
@@ -2140,7 +2140,7 @@
* power peaks, without too much distortion (clipping).
*/
/* we'll fill in this array with h/w max power levels */
- clip_pwrs = (s8 *) priv->clip39_groups[i].clip_powers;
+ clip_pwrs = (s8 *) priv->_3945.clip_groups[i].clip_powers;
/* divide factory saturation power by 2 to find -3dB level */
satur_pwr = (s8) (group->saturation_power >> 1);
@@ -2224,7 +2224,7 @@
iwl3945_hw_reg_get_ch_grp_index(priv, ch_info);
/* Get this chnlgrp's rate->max/clip-powers table */
- clip_pwrs = priv->clip39_groups[ch_info->group_index].clip_powers;
+ clip_pwrs = priv->_3945.clip_groups[ch_info->group_index].clip_powers;
/* calculate power index *adjustment* value according to
* diff between current temperature and factory temperature */
diff --git a/drivers/net/wireless/iwlwifi/iwl-dev.h b/drivers/net/wireless/iwlwifi/iwl-dev.h
index ba404b9..90d2b6e 100644
--- a/drivers/net/wireless/iwlwifi/iwl-dev.h
+++ b/drivers/net/wireless/iwlwifi/iwl-dev.h
@@ -1092,10 +1092,6 @@
struct iwl_channel_info *channel_info; /* channel info array */
u8 channel_count; /* # of channels */
- /* each calibration channel group in the EEPROM has a derived
- * clip setting for each rate. 3945 only.*/
- const struct iwl3945_clip_group clip39_groups[5];
-
/* thermal calibration */
s32 temperature; /* degrees Kelvin */
s32 last_temperature;
@@ -1271,6 +1267,14 @@
/* Rx'd packet timing information */
u32 last_beacon_time;
u64 last_tsf;
+
+ /*
+ * each calibration channel group in the
+ * EEPROM has a derived clip setting for
+ * each rate.
+ */
+ const struct iwl3945_clip_group clip_groups[5];
+
} _3945;
#endif
#if defined(CONFIG_IWLAGN) || defined(CONFIG_IWLAGN_MODULE)