mmc: core: turn the pr_info under CONFIG_MMC_DEBUG into pr_debug
There are lots of debug message in core.c which use pr_debug
for better dynamic log level control. So it doesn't make sense
for those print to still keep working only under CONFIG_MMC_DEBUG.
Signed-off-by: Shawn Lin <shawn.lin@rock-chips.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/core/core.c b/drivers/mmc/core/core.c
index 634f9ca..731aa9f 100644
--- a/drivers/mmc/core/core.c
+++ b/drivers/mmc/core/core.c
@@ -2436,10 +2436,9 @@
{
host->f_init = freq;
-#ifdef CONFIG_MMC_DEBUG
- pr_info("%s: %s: trying to init card at %u Hz\n",
+ pr_debug("%s: %s: trying to init card at %u Hz\n",
mmc_hostname(host), __func__, host->f_init);
-#endif
+
mmc_power_up(host, host->ocr_avail);
/*
@@ -2670,9 +2669,7 @@
{
int ret = 0;
-#ifdef CONFIG_MMC_DEBUG
- pr_info("%s: %s: powering down\n", mmc_hostname(host), __func__);
-#endif
+ pr_debug("%s: %s: powering down\n", mmc_hostname(host), __func__);
mmc_bus_get(host);
@@ -2696,9 +2693,7 @@
{
int ret;
-#ifdef CONFIG_MMC_DEBUG
- pr_info("%s: %s: powering up\n", mmc_hostname(host), __func__);
-#endif
+ pr_debug("%s: %s: powering up\n", mmc_hostname(host), __func__);
mmc_bus_get(host);