cfg80211: 802.11p OCB mode handling
This patch adds new iface type (NL80211_IFTYPE_OCB) representing
the OCB (Outside the Context of a BSS) mode.
When establishing a connection to the network a cfg80211_join_ocb
function is called (particular nl80211_command is added as well).
A mandatory parameters during the ocb_join operation are 'center
frequency' and 'channel width (5/10 MHz)'.
Changes done in mac80211 are minimal possible required to avoid
many warnings (warning: enumeration value 'NL80211_IFTYPE_OCB'
not handled in switch) during compilation. Full functionality
(where needed) is added in the following patch.
Signed-off-by: Rostislav Lisovy <rostislav.lisovy@fel.cvut.cz>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/iface.c b/net/mac80211/iface.c
index 1ffcc07..d69e753 100644
--- a/net/mac80211/iface.c
+++ b/net/mac80211/iface.c
@@ -521,6 +521,7 @@
case NL80211_IFTYPE_MONITOR:
case NL80211_IFTYPE_ADHOC:
case NL80211_IFTYPE_P2P_DEVICE:
+ case NL80211_IFTYPE_OCB:
/* no special treatment */
break;
case NL80211_IFTYPE_UNSPECIFIED:
@@ -631,6 +632,7 @@
case NL80211_IFTYPE_ADHOC:
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_MESH_POINT:
+ case NL80211_IFTYPE_OCB:
netif_carrier_off(dev);
break;
case NL80211_IFTYPE_WDS:
@@ -1351,6 +1353,9 @@
sdata->vif.bss_conf.bssid = sdata->u.mgd.bssid;
ieee80211_sta_setup_sdata(sdata);
break;
+ case NL80211_IFTYPE_OCB:
+ /* to be implemented in the future */
+ break;
case NL80211_IFTYPE_ADHOC:
sdata->vif.bss_conf.bssid = sdata->u.ibss.bssid;
ieee80211_ibss_setup_sdata(sdata);