ARM: mx5/mx53_evk: Use gpio_request_one in mx53_evk_fec_reset
Current code inside mx53_evk_fec_reset uses gpio_direction_output with initial value of the GPIO and also sets
the GPIO value via gpio_set_value right after. This is not needed.
By using gpio_request_one it is possible to set the direction and initial value in one shot.
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Acked-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
diff --git a/arch/arm/mach-mx5/board-mx53_evk.c b/arch/arm/mach-mx5/board-mx53_evk.c
index 7b5735c..d771999 100644
--- a/arch/arm/mach-mx5/board-mx53_evk.c
+++ b/arch/arm/mach-mx5/board-mx53_evk.c
@@ -82,13 +82,12 @@
int ret;
/* reset FEC PHY */
- ret = gpio_request(SMD_FEC_PHY_RST, "fec-phy-reset");
+ ret = gpio_request_one(SMD_FEC_PHY_RST, GPIOF_OUT_INIT_LOW,
+ "fec-phy-reset");
if (ret) {
printk(KERN_ERR"failed to get GPIO_FEC_PHY_RESET: %d\n", ret);
return;
}
- gpio_direction_output(SMD_FEC_PHY_RST, 0);
- gpio_set_value(SMD_FEC_PHY_RST, 0);
msleep(1);
gpio_set_value(SMD_FEC_PHY_RST, 1);
}