[SCSI] qla2xxx: Wait for FLASH write-protection to complete after a write.
Some flash parts have a slow enable write-protection (WP)
operation whereby subsequent FLASH accesses would fail if the WP
operation had not completed. Software now polls the SPI's
status-register for WP completion.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/qla2xxx/qla_sup.c b/drivers/scsi/qla2xxx/qla_sup.c
index ad2fa01..af16c55 100644
--- a/drivers/scsi/qla2xxx/qla_sup.c
+++ b/drivers/scsi/qla2xxx/qla_sup.c
@@ -550,7 +550,7 @@
int ret;
uint32_t liter, miter;
uint32_t sec_mask, rest_addr, conf_addr;
- uint32_t fdata, findex ;
+ uint32_t fdata, findex, cnt;
uint8_t man_id, flash_id;
struct device_reg_24xx __iomem *reg = &ha->iobase->isp24;
dma_addr_t optrom_dma;
@@ -690,8 +690,14 @@
0xff0000) | ((fdata >> 16) & 0xff));
}
- /* Enable flash write-protection. */
+ /* Enable flash write-protection and wait for completion. */
qla24xx_write_flash_dword(ha, flash_conf_to_access_addr(0x101), 0x9c);
+ for (cnt = 300; cnt &&
+ qla24xx_read_flash_dword(ha,
+ flash_conf_to_access_addr(0x005)) & BIT_0;
+ cnt--) {
+ udelay(10);
+ }
/* Disable flash write. */
WRT_REG_DWORD(®->ctrl_status,