net: phy: at803x: use genphy_config_init()
Use the generic bits from genphy_config_init() instead of implementing
the same functionality again.
Signed-off-by: Daniel Mack <zonque@gmail.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index 643464d..b256083 100644
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c
@@ -144,41 +144,11 @@
static int at803x_config_init(struct phy_device *phydev)
{
- int val;
int ret;
- u32 features;
- features = SUPPORTED_TP | SUPPORTED_MII | SUPPORTED_AUI |
- SUPPORTED_FIBRE | SUPPORTED_BNC;
-
- val = phy_read(phydev, MII_BMSR);
- if (val < 0)
- return val;
-
- if (val & BMSR_ANEGCAPABLE)
- features |= SUPPORTED_Autoneg;
- if (val & BMSR_100FULL)
- features |= SUPPORTED_100baseT_Full;
- if (val & BMSR_100HALF)
- features |= SUPPORTED_100baseT_Half;
- if (val & BMSR_10FULL)
- features |= SUPPORTED_10baseT_Full;
- if (val & BMSR_10HALF)
- features |= SUPPORTED_10baseT_Half;
-
- if (val & BMSR_ESTATEN) {
- val = phy_read(phydev, MII_ESTATUS);
- if (val < 0)
- return val;
-
- if (val & ESTATUS_1000_TFULL)
- features |= SUPPORTED_1000baseT_Full;
- if (val & ESTATUS_1000_THALF)
- features |= SUPPORTED_1000baseT_Half;
- }
-
- phydev->supported = features;
- phydev->advertising = features;
+ ret = genphy_config_init(phydev);
+ if (ret < 0)
+ return ret;
if (phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID) {
ret = phy_write(phydev, AT803X_DEBUG_ADDR,