MIPS: Alchemy: move commandline mangling out of common code
Not every alchemy-based board might want these options forced on it,
and most of this stuff seems to be intended for devboard code anyway.
Remove commandline mangling code out of common chip code and instead
add relevant sections to all in-tree boards to not change existing
behaviour.
Signed-off-by: Manuel Lauss <mano@roarinelk.homelinux.net>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/alchemy/mtx-1/board_setup.c b/arch/mips/alchemy/mtx-1/board_setup.c
index 3f80791..8ed1ae1 100644
--- a/arch/mips/alchemy/mtx-1/board_setup.c
+++ b/arch/mips/alchemy/mtx-1/board_setup.c
@@ -32,6 +32,8 @@
#include <asm/mach-au1x00/au1000.h>
+#include <prom.h>
+
extern int (*board_pci_idsel)(unsigned int devsel, int assert);
int mtx1_pci_idsel(unsigned int devsel, int assert);
@@ -43,6 +45,16 @@
void __init board_setup(void)
{
+#ifdef CONFIG_SERIAL_8250_CONSOLE
+ char *argptr;
+ argptr = prom_getcmdline();
+ argptr = strstr(argptr, "console=");
+ if (argptr == NULL) {
+ argptr = prom_getcmdline();
+ strcat(argptr, " console=ttyS0,115200");
+ }
+#endif
+
#if defined(CONFIG_USB_OHCI_HCD) || defined(CONFIG_USB_OHCI_HCD_MODULE)
/* Enable USB power switch */
au_writel(au_readl(GPIO2_DIR) | 0x10, GPIO2_DIR);