netdev: bfin_mac: document TE setting in RMII modes
The current code sometimes generates build warnings due to how it checks
the silicon revision, so clean it up and properly document things.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bfin_mac.c b/drivers/net/bfin_mac.c
index 22abfb3..68d45ba 100644
--- a/drivers/net/bfin_mac.c
+++ b/drivers/net/bfin_mac.c
@@ -1237,8 +1237,17 @@
if (phydev->interface == PHY_INTERFACE_MODE_RMII) {
opmode |= RMII; /* For Now only 100MBit are supported */
-#if (defined(CONFIG_BF537) || defined(CONFIG_BF536)) && CONFIG_BF_REV_0_2
- opmode |= TE;
+#if defined(CONFIG_BF537) || defined(CONFIG_BF536)
+ if (__SILICON_REVISION__ < 3) {
+ /*
+ * This isn't publicly documented (fun times!), but in
+ * silicon <=0.2, the RX and TX pins are clocked together.
+ * So in order to recv, we must enable the transmit side
+ * as well. This will cause a spurious TX interrupt too,
+ * but we can easily consume that.
+ */
+ opmode |= TE;
+ }
#endif
}