bnx2x: Swap BCM8073 PHY polarity if required
Enable controlling BCM8073 PN polarity swap through nvm configuration, which is required in certain systems
Signed-off-by: Yaniv Rosner <yanivr@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2x/bnx2x_link.c b/drivers/net/bnx2x/bnx2x_link.c
index 43b0de2..77f9eb19 100644
--- a/drivers/net/bnx2x/bnx2x_link.c
+++ b/drivers/net/bnx2x/bnx2x_link.c
@@ -4108,6 +4108,25 @@
DP(NETIF_MSG_LINK, "Before rom RX_ALARM(port1): 0x%x\n", tmp1);
+ /**
+ * If this is forced speed, set to KR or KX (all other are not
+ * supported)
+ */
+ /* Swap polarity if required - Must be done only in non-1G mode */
+ if (params->lane_config & PORT_HW_CFG_SWAP_PHY_POLARITY_ENABLED) {
+ /* Configure the 8073 to swap _P and _N of the KR lines */
+ DP(NETIF_MSG_LINK, "Swapping polarity for the 8073\n");
+ /* 10G Rx/Tx and 1G Tx signal polarity swap */
+ bnx2x_cl45_read(bp, phy,
+ MDIO_PMA_DEVAD,
+ MDIO_PMA_REG_8073_OPT_DIGITAL_CTRL, &val);
+ bnx2x_cl45_write(bp, phy,
+ MDIO_PMA_DEVAD,
+ MDIO_PMA_REG_8073_OPT_DIGITAL_CTRL,
+ (val | (3<<9)));
+ }
+
+
/* Enable CL37 BAM */
if (REG_RD(bp, params->shmem_base +
offsetof(struct shmem_region, dev_info.
@@ -4314,6 +4333,29 @@
}
if (link_up) {
+ /* Swap polarity if required */
+ if (params->lane_config &
+ PORT_HW_CFG_SWAP_PHY_POLARITY_ENABLED) {
+ /* Configure the 8073 to swap P and N of the KR lines */
+ bnx2x_cl45_read(bp, phy,
+ MDIO_XS_DEVAD,
+ MDIO_XS_REG_8073_RX_CTRL_PCIE, &val1);
+ /**
+ * Set bit 3 to invert Rx in 1G mode and clear this bit
+ * when it`s in 10G mode.
+ */
+ if (vars->line_speed == SPEED_1000) {
+ DP(NETIF_MSG_LINK, "Swapping 1G polarity for"
+ "the 8073\n");
+ val1 |= (1<<3);
+ } else
+ val1 &= ~(1<<3);
+
+ bnx2x_cl45_write(bp, phy,
+ MDIO_XS_DEVAD,
+ MDIO_XS_REG_8073_RX_CTRL_PCIE,
+ val1);
+ }
bnx2x_ext_phy_10G_an_resolve(bp, phy, vars);
bnx2x_8073_resolve_fc(phy, params, vars);
}