IB/qib: Clean up properly if qib_init() fails
If qib_init() fails, the driver fails to free memory, unregister
device files, and unregister with the PCIe framework. The driver will
unload without error but a subsequent driver load will cause the
system to panic. This was found by changing the 7220 code to load the
serdes microcode separately and not installing the microcode file.
Signed-off-by: Ralph Campbell <ralph.campbell@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/qib/qib_init.c b/drivers/infiniband/hw/qib/qib_init.c
index 7831ff8..a873dd5 100644
--- a/drivers/infiniband/hw/qib/qib_init.c
+++ b/drivers/infiniband/hw/qib/qib_init.c
@@ -1289,8 +1289,18 @@
if (qib_mini_init || initfail || ret) {
qib_stop_timers(dd);
+ flush_scheduled_work();
for (pidx = 0; pidx < dd->num_pports; ++pidx)
dd->f_quiet_serdes(dd->pport + pidx);
+ if (qib_mini_init)
+ goto bail;
+ if (!j) {
+ (void) qibfs_remove(dd);
+ qib_device_remove(dd);
+ }
+ if (!ret)
+ qib_unregister_ib_device(dd);
+ qib_postinit_cleanup(dd);
if (initfail)
ret = initfail;
goto bail;