gpio: add TS-5500 DIO blocks support
Technologic Systems TS-5500 provides digital I/O lines exposed through
pin blocks. On this platform, there are three of them, named DIO1, DIO2
and LCD port, that may be used as a DIO block.
The TS-5500 pin blocks are described in the product's wiki:
http://wiki.embeddedarm.com/wiki/TS-5500#Digital_I.2FO
This driver is not limited to the TS-5500 blocks. It can be extended to
support similar boards pin blocks, such as on the TS-5600.
This patch is the V2 of the previous https://lkml.org/lkml/2012/9/25/671
with corrections suggested by Linus Walleij.
Signed-off-by: Vivien Didelot <vivien.didelot@savoirfairelinux.com>
Signed-off-by: Jerome Oufella <jerome.oufella@savoirfairelinux.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index 46e96f3..39d9323 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -211,6 +211,14 @@
Say yes here to support the STA2x11/ConneXt GPIO device.
The GPIO module has 128 GPIO pins with alternate functions.
+config GPIO_TS5500
+ tristate "TS-5500 DIO blocks and compatibles"
+ help
+ This driver supports Digital I/O exposed by pin blocks found on some
+ Technologic Systems platforms. It includes, but is not limited to, 3
+ blocks of the TS-5500: DIO1, DIO2 and the LCD port, and the TS-5600
+ LCD port.
+
config GPIO_VT8500
bool "VIA/Wondermedia SoC GPIO Support"
depends on ARCH_VT8500