sctp: implement sctp association probing module
This patch implement sctp association probing module, the module
will be called sctp_probe.
This module allows for capturing the changes to SCTP association
state in response to incoming packets. It is used for debugging
SCTP congestion control algorithms.
Usage:
$ modprobe sctp_probe [full=n] [port=n] [bufsize=n]
$ cat /proc/net/sctpprobe
The output format is:
TIME ASSOC LPORT RPORT MTU RWND UNACK <REMOTE-ADDR STATE CWND SSTHRESH INFLIGHT PARTIAL_BYTES_ACKED MTU> ...
The output will be like this:
9.226086 c4064c48 9000 8000 1500 53352 1 *192.168.0.19 1 4380 54784 1252 0 1500
9.287195 c4064c48 9000 8000 1500 45144 5 *192.168.0.19 1 5880 54784 6500 0 1500
9.289130 c4064c48 9000 8000 1500 42724 5 *192.168.0.19 1 7380 54784 6500 0 1500
9.620332 c4064c48 9000 8000 1500 48284 4 *192.168.0.19 1 8880 54784 5200 0 1500
......
Signed-off-by: Wei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: Vlad Yasevich <vladislav.yasevich@hp.com>
diff --git a/net/sctp/Kconfig b/net/sctp/Kconfig
index 58b3e88..126b014e 100644
--- a/net/sctp/Kconfig
+++ b/net/sctp/Kconfig
@@ -37,6 +37,18 @@
if IP_SCTP
+config NET_SCTPPROBE
+ tristate "SCTP: Association probing"
+ depends on PROC_FS && KPROBES
+ ---help---
+ This module allows for capturing the changes to SCTP association
+ state in response to incoming packets. It is used for debugging
+ SCTP congestion control algorithms. If you don't understand
+ what was just said, you don't need it: say N.
+
+ To compile this code as a module, choose M here: the
+ module will be called sctp_probe.
+
config SCTP_DBG_MSG
bool "SCTP: Debug messages"
help