diff --git a/include/linux/netdevice.h b/include/linux/netdevice.h
index 5e84483..1a86948 100644
--- a/include/linux/netdevice.h
+++ b/include/linux/netdevice.h
@@ -1147,6 +1147,89 @@
 							void *priv);
 };
 
+/**
+ * enum net_device_priv_flags - &struct net_device priv_flags
+ *
+ * These are the &struct net_device, they are only set internally
+ * by drivers and used in the kernel. These flags are invisible to
+ * userspace, this means that the order of these flags can change
+ * during any kernel release.
+ *
+ * You should have a pretty good reason to be extending these flags.
+ *
+ * @IFF_802_1Q_VLAN: 802.1Q VLAN device
+ * @IFF_EBRIDGE: Ethernet bridging device
+ * @IFF_SLAVE_INACTIVE: bonding slave not the curr. active
+ * @IFF_MASTER_8023AD: bonding master, 802.3ad
+ * @IFF_MASTER_ALB: bonding master, balance-alb
+ * @IFF_BONDING: bonding master or slave
+ * @IFF_SLAVE_NEEDARP: need ARPs for validation
+ * @IFF_ISATAP: ISATAP interface (RFC4214)
+ * @IFF_MASTER_ARPMON: bonding master, ARP mon in use
+ * @IFF_WAN_HDLC: WAN HDLC device
+ * @IFF_XMIT_DST_RELEASE: dev_hard_start_xmit() is allowed to
+ *	release skb->dst
+ * @IFF_DONT_BRIDGE: disallow bridging this ether dev
+ * @IFF_DISABLE_NETPOLL: disable netpoll at run-time
+ * @IFF_MACVLAN_PORT: device used as macvlan port
+ * @IFF_BRIDGE_PORT: device used as bridge port
+ * @IFF_OVS_DATAPATH: device used as Open vSwitch datapath port
+ * @IFF_TX_SKB_SHARING: The interface supports sharing skbs on transmit
+ * @IFF_UNICAST_FLT: Supports unicast filtering
+ * @IFF_TEAM_PORT: device used as team port
+ * @IFF_SUPP_NOFCS: device supports sending custom FCS
+ * @IFF_LIVE_ADDR_CHANGE: device supports hardware address
+ *	change when it's running
+ * @IFF_MACVLAN: Macvlan device
+ */
+enum netdev_priv_flags {
+	IFF_802_1Q_VLAN			= 1<<0,
+	IFF_EBRIDGE			= 1<<1,
+	IFF_SLAVE_INACTIVE		= 1<<2,
+	IFF_MASTER_8023AD		= 1<<3,
+	IFF_MASTER_ALB			= 1<<4,
+	IFF_BONDING			= 1<<5,
+	IFF_SLAVE_NEEDARP		= 1<<6,
+	IFF_ISATAP			= 1<<7,
+	IFF_MASTER_ARPMON		= 1<<8,
+	IFF_WAN_HDLC			= 1<<9,
+	IFF_XMIT_DST_RELEASE		= 1<<10,
+	IFF_DONT_BRIDGE			= 1<<11,
+	IFF_DISABLE_NETPOLL		= 1<<12,
+	IFF_MACVLAN_PORT		= 1<<13,
+	IFF_BRIDGE_PORT			= 1<<14,
+	IFF_OVS_DATAPATH		= 1<<15,
+	IFF_TX_SKB_SHARING		= 1<<16,
+	IFF_UNICAST_FLT			= 1<<17,
+	IFF_TEAM_PORT			= 1<<18,
+	IFF_SUPP_NOFCS			= 1<<19,
+	IFF_LIVE_ADDR_CHANGE		= 1<<20,
+	IFF_MACVLAN			= 1<<21,
+};
+
+#define IFF_802_1Q_VLAN			IFF_802_1Q_VLAN
+#define IFF_EBRIDGE			IFF_EBRIDGE
+#define IFF_SLAVE_INACTIVE		IFF_SLAVE_INACTIVE
+#define IFF_MASTER_8023AD		IFF_MASTER_8023AD
+#define IFF_MASTER_ALB			IFF_MASTER_ALB
+#define IFF_BONDING			IFF_BONDING
+#define IFF_SLAVE_NEEDARP		IFF_SLAVE_NEEDARP
+#define IFF_ISATAP			IFF_ISATAP
+#define IFF_MASTER_ARPMON		IFF_MASTER_ARPMON
+#define IFF_WAN_HDLC			IFF_WAN_HDLC
+#define IFF_XMIT_DST_RELEASE		IFF_XMIT_DST_RELEASE
+#define IFF_DONT_BRIDGE			IFF_DONT_BRIDGE
+#define IFF_DISABLE_NETPOLL		IFF_DISABLE_NETPOLL
+#define IFF_MACVLAN_PORT		IFF_MACVLAN_PORT
+#define IFF_BRIDGE_PORT			IFF_BRIDGE_PORT
+#define IFF_OVS_DATAPATH		IFF_OVS_DATAPATH
+#define IFF_TX_SKB_SHARING		IFF_TX_SKB_SHARING
+#define IFF_UNICAST_FLT			IFF_UNICAST_FLT
+#define IFF_TEAM_PORT			IFF_TEAM_PORT
+#define IFF_SUPP_NOFCS			IFF_SUPP_NOFCS
+#define IFF_LIVE_ADDR_CHANGE		IFF_LIVE_ADDR_CHANGE
+#define IFF_MACVLAN			IFF_MACVLAN
+
 /*
  *	The DEVICE structure.
  *	Actually, this whole structure is a big mistake.  It mixes I/O
diff --git a/include/uapi/linux/if.h b/include/uapi/linux/if.h
index 42ec879..9cf2394 100644
--- a/include/uapi/linux/if.h
+++ b/include/uapi/linux/if.h
@@ -112,89 +112,6 @@
 #define IFF_VOLATILE	(IFF_LOOPBACK|IFF_POINTOPOINT|IFF_BROADCAST|IFF_ECHO|\
 		IFF_MASTER|IFF_SLAVE|IFF_RUNNING|IFF_LOWER_UP|IFF_DORMANT)
 
-/**
- * enum net_device_priv_flags - &struct net_device priv_flags
- *
- * These are the &struct net_device, they are only set internally
- * by drivers and used in the kernel. These flags are invisible to
- * userspace, this means that the order of these flags can change
- * during any kernel release.
- *
- * You should have a pretty good reason to be extending these flags.
- *
- * @IFF_802_1Q_VLAN: 802.1Q VLAN device
- * @IFF_EBRIDGE: Ethernet bridging device
- * @IFF_SLAVE_INACTIVE: bonding slave not the curr. active
- * @IFF_MASTER_8023AD: bonding master, 802.3ad
- * @IFF_MASTER_ALB: bonding master, balance-alb
- * @IFF_BONDING: bonding master or slave
- * @IFF_SLAVE_NEEDARP: need ARPs for validation
- * @IFF_ISATAP: ISATAP interface (RFC4214)
- * @IFF_MASTER_ARPMON: bonding master, ARP mon in use
- * @IFF_WAN_HDLC: WAN HDLC device
- * @IFF_XMIT_DST_RELEASE: dev_hard_start_xmit() is allowed to
- *	release skb->dst
- * @IFF_DONT_BRIDGE: disallow bridging this ether dev
- * @IFF_DISABLE_NETPOLL: disable netpoll at run-time
- * @IFF_MACVLAN_PORT: device used as macvlan port
- * @IFF_BRIDGE_PORT: device used as bridge port
- * @IFF_OVS_DATAPATH: device used as Open vSwitch datapath port
- * @IFF_TX_SKB_SHARING: The interface supports sharing skbs on transmit
- * @IFF_UNICAST_FLT: Supports unicast filtering
- * @IFF_TEAM_PORT: device used as team port
- * @IFF_SUPP_NOFCS: device supports sending custom FCS
- * @IFF_LIVE_ADDR_CHANGE: device supports hardware address
- *	change when it's running
- * @IFF_MACVLAN: Macvlan device
- */
-enum netdev_priv_flags {
-	IFF_802_1Q_VLAN			= 1<<0,
-	IFF_EBRIDGE			= 1<<1,
-	IFF_SLAVE_INACTIVE		= 1<<2,
-	IFF_MASTER_8023AD		= 1<<3,
-	IFF_MASTER_ALB			= 1<<4,
-	IFF_BONDING			= 1<<5,
-	IFF_SLAVE_NEEDARP		= 1<<6,
-	IFF_ISATAP			= 1<<7,
-	IFF_MASTER_ARPMON		= 1<<8,
-	IFF_WAN_HDLC			= 1<<9,
-	IFF_XMIT_DST_RELEASE		= 1<<10,
-	IFF_DONT_BRIDGE			= 1<<11,
-	IFF_DISABLE_NETPOLL		= 1<<12,
-	IFF_MACVLAN_PORT		= 1<<13,
-	IFF_BRIDGE_PORT			= 1<<14,
-	IFF_OVS_DATAPATH		= 1<<15,
-	IFF_TX_SKB_SHARING		= 1<<16,
-	IFF_UNICAST_FLT			= 1<<17,
-	IFF_TEAM_PORT			= 1<<18,
-	IFF_SUPP_NOFCS			= 1<<19,
-	IFF_LIVE_ADDR_CHANGE		= 1<<20,
-	IFF_MACVLAN			= 1<<21,
-};
-
-#define IFF_802_1Q_VLAN			IFF_802_1Q_VLAN
-#define IFF_EBRIDGE			IFF_EBRIDGE
-#define IFF_SLAVE_INACTIVE		IFF_SLAVE_INACTIVE
-#define IFF_MASTER_8023AD		IFF_MASTER_8023AD
-#define IFF_MASTER_ALB			IFF_MASTER_ALB
-#define IFF_BONDING			IFF_BONDING
-#define IFF_SLAVE_NEEDARP		IFF_SLAVE_NEEDARP
-#define IFF_ISATAP			IFF_ISATAP
-#define IFF_MASTER_ARPMON		IFF_MASTER_ARPMON
-#define IFF_WAN_HDLC			IFF_WAN_HDLC
-#define IFF_XMIT_DST_RELEASE		IFF_XMIT_DST_RELEASE
-#define IFF_DONT_BRIDGE			IFF_DONT_BRIDGE
-#define IFF_DISABLE_NETPOLL		IFF_DISABLE_NETPOLL
-#define IFF_MACVLAN_PORT		IFF_MACVLAN_PORT
-#define IFF_BRIDGE_PORT			IFF_BRIDGE_PORT
-#define IFF_OVS_DATAPATH		IFF_OVS_DATAPATH
-#define IFF_TX_SKB_SHARING		IFF_TX_SKB_SHARING
-#define IFF_UNICAST_FLT			IFF_UNICAST_FLT
-#define IFF_TEAM_PORT			IFF_TEAM_PORT
-#define IFF_SUPP_NOFCS			IFF_SUPP_NOFCS
-#define IFF_LIVE_ADDR_CHANGE		IFF_LIVE_ADDR_CHANGE
-#define IFF_MACVLAN			IFF_MACVLAN
-
 #define IF_GET_IFACE	0x0001		/* for querying only */
 #define IF_GET_PROTO	0x0002