Merge tag 'arm-soc/for-4.10/devicetree-arm64' of http://github.com/Broadcom/stblinux into next/dt64
Pull "Broadcom devicetree-arm64 changes for 4.10" from Florian Fainelli:
This pull request contains Broadcom ARM64 based SoC Device Tree changes for
4.10, please pull the following:
- Robin updates the Northstart 2 DTS to use the generic IOMMU binding
- Scott renames the Broadcom Northstar 2 binding document to use a standard name
including the brcm vendor prefix
- Kamal adds the QSPI Device Tree node to the Northstar 2 SoC and updates the
Northstar 2 SVK reference board DTS file with it enabled.
- Rob adds the Device Tree node for the Broadcom PDC (mailbox) hardware to the
Northstar 2 SoC
- Jon enables the SDIO1 block and adds proper PCIe PHYs Device Tree nodes to the
Northstar 2 SoC
- Ray adds required properties NAND controller properties to make NAND work on
the Northstar 2 SVK board, this was submitted as a 4.9 fixes and is included
here to resolve DTS file merges
- Andrea removes an incorrect power LED from the Raspberry Pi 3 DTS
- Andreas fixes the compatible string for the BCM2837 (Raspberry Pi 3)
- Eric defines standard pinctrl groups in the BCM2835 GPIO node
- Gerd adds definitions for the pinctrl groups and updates the PWM, I2C and SDHCI nodes
to use their appropriate pinctrl functions
- Linus adds names for the Raspberry Pi GPIO lines based on the datasheet
- Martin adds the DT binding and nodes for the Raspberry Pi firmware thermal block
- Stefan fixes a few typos with respect to the BCM2835 mailbox binding example and
Device Tree nodes he also uses the proper DTSI file to define the USB host mode
for the USB Device Tree nodes
* tag 'arm-soc/for-4.10/devicetree-arm64' of http://github.com/Broadcom/stblinux: (23 commits)
arm64: dts: NS2: Add PCI PHYs
arm64: dts: NS2: enable sdio1
ARM64: dts: bcm2837-rpi-3-b: remove incorrect pwr LED
ARM64: bcm2835: dts: add thermal node to device-tree of bcm2837
ARM: bcm2835: Add names for the Raspberry Pi GPIO lines
ARM: bcm2835: dts: add thermal node to device-tree of bcm283x
dt: bindings: add thermal device driver for bcm2835
arm64: dts: Add Broadcom Northstar2 device tree entries for PDC driver.
ARM: dts: bcm283x: fix typo in mailbox address
DT: binding: bcm2835-mbox: fix address typo in example
ARM64: dts: bcm2835: Fix bcm2837 compatible string
arm64: dts: Update Broadcom NS2 to generic IOMMU binding
arm64: dts: Updated NAND DT properties for NS2 SVK
arm64: dts: rename ns2.txt to brcm,ns2.txt
ARM64: dts: Add QSPI Device Tree node for NS2
ARM64: dts: bcm283x: Use dtsi for USB host mode
ARM: dts: bcm283x: drop alt3 from &gpio
ARM: dts: bcm283x: add pinctrl group to &sdhci, drop pins from &gpio
ARM: dts: bcm283x: add pinctrl group to &i2c1, drop pins from &gpio
ARM: dts: bcm283x: add pinctrl group to &i2c0, drop pins from &gpio
...