[SCSI] qla2xxx: Correct 'loop-down' determination logic in qla2x00_fw_ready().
As there is no point in failing the initialization process when
firmware informs the host software that it could not transition
beyond a CONFIG_WAIT nor WAIT_FOR_LOGIN state. Previous logic
would mark such conditions as a general *failure* and subsequently
tear-down the scsi-host during initialization.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index 761dd1f..c7ab668 100644
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -1273,8 +1273,7 @@
rval = QLA_FUNCTION_FAILED;
if (atomic_read(&ha->loop_down_timer) &&
- (fw_state >= FSTATE_LOSS_OF_SYNC ||
- fw_state == FSTATE_WAIT_AL_PA)) {
+ fw_state != FSTATE_READY) {
/* Loop down. Timeout on min_wait for states
* other than Wait for Login.
*/