arm64: mm: report unhandled level-0 translation faults correctly
Translation faults that occur due to the input address being outside
of the address range mapped by the relevant base register are reported
as level 0 faults in ESR.DFSC.
If the faulting access cannot be resolved by the kernel (e.g. because
it is not mapped by a vma), then we report "input address range fault"
on the console. This was fine until we added support for 48-bit VAs,
which actually place PGDs at level 0 and can trigger faults for invalid
addresses that are within the range of the page tables.
This patch changes the string to report "level 0 translation fault",
which is far less confusing.
Signed-off-by: Will Deacon <will.deacon@arm.com>
diff --git a/arch/arm64/mm/fault.c b/arch/arm64/mm/fault.c
index 41cb6d3..c11cd27 100644
--- a/arch/arm64/mm/fault.c
+++ b/arch/arm64/mm/fault.c
@@ -380,7 +380,7 @@
{ do_bad, SIGBUS, 0, "level 1 address size fault" },
{ do_bad, SIGBUS, 0, "level 2 address size fault" },
{ do_bad, SIGBUS, 0, "level 3 address size fault" },
- { do_translation_fault, SIGSEGV, SEGV_MAPERR, "input address range fault" },
+ { do_translation_fault, SIGSEGV, SEGV_MAPERR, "level 0 translation fault" },
{ do_translation_fault, SIGSEGV, SEGV_MAPERR, "level 1 translation fault" },
{ do_translation_fault, SIGSEGV, SEGV_MAPERR, "level 2 translation fault" },
{ do_page_fault, SIGSEGV, SEGV_MAPERR, "level 3 translation fault" },