CLK: ti: add init support for clock IP blocks
ti_dt_clk_init_provider() can now be used to initialize the contents of
a single clock IP block. This parses all the clocks under the IP block
and calls the corresponding init function for them.
This patch also introduces a helper function for the TI clock drivers
to get register info from DT and append the master IP info to this.
Signed-off-by: Tero Kristo <t-kristo@ti.com>
Acked-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Mike Turquette <mturquette@linaro.org>
diff --git a/include/linux/clk/ti.h b/include/linux/clk/ti.h
index df94c24..c6eded5 100644
--- a/include/linux/clk/ti.h
+++ b/include/linux/clk/ti.h
@@ -36,7 +36,42 @@
.node_name = name, \
}
+/* Maximum number of clock memmaps */
+#define CLK_MAX_MEMMAPS 4
+typedef void (*ti_of_clk_init_cb_t)(struct clk_hw *, struct device_node *);
+
+/**
+ * struct clk_omap_reg - OMAP register declaration
+ * @offset: offset from the master IP module base address
+ * @index: index of the master IP module
+ */
+struct clk_omap_reg {
+ u16 offset;
+ u16 index;
+};
+
+/**
+ * struct ti_clk_ll_ops - low-level register access ops for a clock
+ * @clk_readl: pointer to register read function
+ * @clk_writel: pointer to register write function
+ *
+ * Low-level register access ops are generally used by the basic clock types
+ * (clk-gate, clk-mux, clk-divider etc.) to provide support for various
+ * low-level hardware interfaces (direct MMIO, regmap etc.), but can also be
+ * used by other hardware-specific clock drivers if needed.
+ */
+struct ti_clk_ll_ops {
+ u32 (*clk_readl)(void __iomem *reg);
+ void (*clk_writel)(u32 val, void __iomem *reg);
+};
+
+extern struct ti_clk_ll_ops *ti_clk_ll_ops;
+
+void __iomem *ti_clk_get_reg_addr(struct device_node *node, int index);
void ti_dt_clocks_register(struct ti_dt_clk *oclks);
+void ti_dt_clk_init_provider(struct device_node *np, int index);
+int ti_clk_retry_init(struct device_node *node, struct clk_hw *hw,
+ ti_of_clk_init_cb_t func);
#endif