OMAP: GPIO: Avoid generating extra IRQs
It is possible for GPIO IRQ lines configured with
falling edge triggering only to get IRQs at the
rising edge upon the exit of offmode. And vice
versa. Prevent such IRQs to arrive by generating
the IRQ obeying the detection scheme.
Signed-off-by: Eero Nurkkala <ext-eero.nurkkala@nokia.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/plat-omap/gpio.c b/arch/arm/plat-omap/gpio.c
index b55b4ad..7c70a6a 100644
--- a/arch/arm/plat-omap/gpio.c
+++ b/arch/arm/plat-omap/gpio.c
@@ -1895,7 +1895,7 @@
return;
for (i = 0; i < gpio_bank_count; i++) {
struct gpio_bank *bank = &gpio_bank[i];
- u32 l;
+ u32 l, gen, gen0, gen1;
if (!(bank->enabled_non_wakeup_gpios))
continue;
@@ -1916,14 +1916,33 @@
#endif
l ^= bank->saved_datain;
l &= bank->non_wakeup_gpios;
- if (l) {
+
+ /*
+ * No need to generate IRQs for the rising edge for gpio IRQs
+ * configured with falling edge only; and vice versa.
+ */
+ gen0 = l & bank->saved_fallingdetect;
+ gen0 &= bank->saved_datain;
+
+ gen1 = l & bank->saved_risingdetect;
+ gen1 &= ~(bank->saved_datain);
+
+ /* FIXME: Consider GPIO IRQs with level detections properly! */
+ gen = l & (~(bank->saved_fallingdetect) &
+ ~(bank->saved_risingdetect));
+ /* Consider all GPIO IRQs needed to be updated */
+ gen |= gen0 | gen1;
+
+ if (gen) {
u32 old0, old1;
#if defined(CONFIG_ARCH_OMAP24XX) || defined(CONFIG_ARCH_OMAP34XX) || \
defined(CONFIG_ARCH_OMAP4)
old0 = __raw_readl(bank->base + OMAP24XX_GPIO_LEVELDETECT0);
old1 = __raw_readl(bank->base + OMAP24XX_GPIO_LEVELDETECT1);
- __raw_writel(old0 | l, bank->base + OMAP24XX_GPIO_LEVELDETECT0);
- __raw_writel(old1 | l, bank->base + OMAP24XX_GPIO_LEVELDETECT1);
+ __raw_writel(old0 | gen, bank->base +
+ OMAP24XX_GPIO_LEVELDETECT0);
+ __raw_writel(old1 | gen, bank->base +
+ OMAP24XX_GPIO_LEVELDETECT1);
__raw_writel(old0, bank->base + OMAP24XX_GPIO_LEVELDETECT0);
__raw_writel(old1, bank->base + OMAP24XX_GPIO_LEVELDETECT1);
#endif