stmmac: dity-up and rework the driver debug levels
Prior this patch, the internal debugging was based on ifdef
and also some printk were useless because many info are exposed
via ethtool.
This patch remove all the ifdef defines and now we only use
netif_msg_XXX levels.
Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac100_dma.c b/drivers/net/ethernet/stmicro/stmmac/dwmac100_dma.c
index 67551c1..7d1dce9 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac100_dma.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac100_dma.c
@@ -90,14 +90,14 @@
{
int i;
- CHIP_DBG(KERN_DEBUG "DWMAC 100 DMA CSR\n");
+ pr_debug("DWMAC 100 DMA CSR\n");
for (i = 0; i < 9; i++)
pr_debug("\t CSR%d (offset 0x%x): 0x%08x\n", i,
(DMA_BUS_MODE + i * 4),
readl(ioaddr + DMA_BUS_MODE + i * 4));
- CHIP_DBG(KERN_DEBUG "\t CSR20 (offset 0x%x): 0x%08x\n",
- DMA_CUR_TX_BUF_ADDR, readl(ioaddr + DMA_CUR_TX_BUF_ADDR));
- CHIP_DBG(KERN_DEBUG "\t CSR21 (offset 0x%x): 0x%08x\n",
+
+ pr_debug("\tCSR20 (0x%x): 0x%08x, CSR21 (0x%x): 0x%08x\n",
+ DMA_CUR_TX_BUF_ADDR, readl(ioaddr + DMA_CUR_TX_BUF_ADDR),
DMA_CUR_RX_BUF_ADDR, readl(ioaddr + DMA_CUR_RX_BUF_ADDR));
}