usb: Store bus type in usb_hcd, not in driver flags.
The xHCI driver essentially has both a USB 2.0 and a USB 3.0 roothub. So
setting the HCD_USB3 bits in the hcd->driver->flags is a bit misleading.
Add a new field to usb_hcd, bcdUSB. Store the result of
hcd->driver->flags & HCD_MASK in it. Later, when we have the xHCI driver
register the two roothubs, we'll set the usb_hcd->bcdUSB field to HCD_USB2
for the USB 2.0 roothub, and HCD_USB3 for the USB 3.0 roothub.
Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
diff --git a/drivers/usb/core/hcd.c b/drivers/usb/core/hcd.c
index 3ba2711..a0adcac 100644
--- a/drivers/usb/core/hcd.c
+++ b/drivers/usb/core/hcd.c
@@ -507,7 +507,7 @@
case DeviceRequest | USB_REQ_GET_DESCRIPTOR:
switch (wValue & 0xff00) {
case USB_DT_DEVICE << 8:
- switch (hcd->driver->flags & HCD_MASK) {
+ switch (hcd->speed) {
case HCD_USB3:
bufp = usb3_rh_dev_descriptor;
break;
@@ -525,7 +525,7 @@
patch_protocol = 1;
break;
case USB_DT_CONFIG << 8:
- switch (hcd->driver->flags & HCD_MASK) {
+ switch (hcd->speed) {
case HCD_USB3:
bufp = ss_rh_config_descriptor;
len = sizeof ss_rh_config_descriptor;
@@ -2216,6 +2216,7 @@
#endif
hcd->driver = driver;
+ hcd->speed = driver->flags & HCD_MASK;
hcd->product_desc = (driver->product_desc) ? driver->product_desc :
"USB Host Controller";
return hcd;
@@ -2325,7 +2326,7 @@
}
hcd->self.root_hub = rhdev;
- switch (hcd->driver->flags & HCD_MASK) {
+ switch (hcd->speed) {
case HCD_USB11:
rhdev->speed = USB_SPEED_FULL;
break;