drbd: add some more explicit drbd_md_sync
It sometimes may take a while for the after state change work to be
scheduled, which does drbd_md_sync. At convenient places, we should do
explicit drbd_md_sync to have the new state information on disk as soon
as possible.
Signed-off-by: Philipp Reisner <philipp.reisner@linbit.com>
Signed-off-by: Lars Ellenberg <lars.ellenberg@linbit.com>
diff --git a/drivers/block/drbd/drbd_receiver.c b/drivers/block/drbd/drbd_receiver.c
index 5a4b6dc..6ec922c 100644
--- a/drivers/block/drbd/drbd_receiver.c
+++ b/drivers/block/drbd/drbd_receiver.c
@@ -3804,6 +3804,9 @@
err_out:
drbd_force_state(mdev, NS(conn, C_PROTOCOL_ERROR));
}
+ /* If we leave here, we probably want to update at least the
+ * "Connected" indicator on stable storage. Do so explicitly here. */
+ drbd_md_sync(mdev);
}
void drbd_flush_workqueue(struct drbd_conf *mdev)
@@ -4685,10 +4688,12 @@
if (0) {
reconnect:
drbd_force_state(mdev, NS(conn, C_NETWORK_FAILURE));
+ drbd_md_sync(mdev);
}
if (0) {
disconnect:
drbd_force_state(mdev, NS(conn, C_DISCONNECTING));
+ drbd_md_sync(mdev);
}
clear_bit(SIGNAL_ASENDER, &mdev->flags);