Blackfin arch: Add BF537-STAMP platform support for ENC28J60 SPI Ethernet MAC
This device shouldn't be considered as an alternative to a Memory Mapped
or built-in Ethernet MAC. Throughput is slow (~460kByte/s) while generating
a very high system load (~60%).
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
diff --git a/arch/blackfin/mach-bf537/boards/stamp.c b/arch/blackfin/mach-bf537/boards/stamp.c
index e6e722d..c198f90 100644
--- a/arch/blackfin/mach-bf537/boards/stamp.c
+++ b/arch/blackfin/mach-bf537/boards/stamp.c
@@ -623,6 +623,14 @@
};
#endif
+#if defined(CONFIG_ENC28J60) || defined(CONFIG_ENC28J60_MODULE)
+static struct bfin5xx_spi_chip enc28j60_spi_chip_info = {
+ .enable_dma = 1,
+ .bits_per_word = 8,
+ .cs_gpio = GPIO_PF10,
+};
+#endif
+
#if defined(CONFIG_MTD_DATAFLASH) \
|| defined(CONFIG_MTD_DATAFLASH_MODULE)
@@ -784,6 +792,17 @@
.mode = SPI_CPHA | SPI_CPOL,
},
#endif
+#if defined(CONFIG_ENC28J60) || defined(CONFIG_ENC28J60_MODULE)
+ {
+ .modalias = "enc28j60",
+ .max_speed_hz = 20000000, /* max spi clock (SCK) speed in HZ */
+ .irq = IRQ_PF6,
+ .bus_num = 0,
+ .chip_select = 0, /* GPIO controlled SSEL */
+ .controller_data = &enc28j60_spi_chip_info,
+ .mode = SPI_MODE_0,
+ },
+#endif
};
#if defined(CONFIG_SPI_BFIN) || defined(CONFIG_SPI_BFIN_MODULE)