Merge branch 'nvme-4.12' of git://git.infradead.org/nvme into for-linus
Christoph writes:
"A few NVMe fixes for 4.12-rc, PCIe reset fixes and APST fixes, a
RDMA reconnect fix, two FC fixes and a general controller removal fix."
diff --git a/drivers/nvme/host/core.c b/drivers/nvme/host/core.c
index a609264..903d581 100644
--- a/drivers/nvme/host/core.c
+++ b/drivers/nvme/host/core.c
@@ -56,7 +56,7 @@
static int nvme_char_major;
module_param(nvme_char_major, int, 0);
-static unsigned long default_ps_max_latency_us = 25000;
+static unsigned long default_ps_max_latency_us = 100000;
module_param(default_ps_max_latency_us, ulong, 0644);
MODULE_PARM_DESC(default_ps_max_latency_us,
"max power saving latency for new devices; use PM QOS to change per device");
@@ -1342,7 +1342,7 @@
* transitioning between power states. Therefore, when running
* in any given state, we will enter the next lower-power
* non-operational state after waiting 50 * (enlat + exlat)
- * microseconds, as long as that state's total latency is under
+ * microseconds, as long as that state's exit latency is under
* the requested maximum latency.
*
* We will not autonomously enter any non-operational state for
@@ -1387,7 +1387,7 @@
* lowest-power state, not the number of states.
*/
for (state = (int)ctrl->npss; state >= 0; state--) {
- u64 total_latency_us, transition_ms;
+ u64 total_latency_us, exit_latency_us, transition_ms;
if (target)
table->entries[state] = target;
@@ -1408,12 +1408,15 @@
NVME_PS_FLAGS_NON_OP_STATE))
continue;
- total_latency_us =
- (u64)le32_to_cpu(ctrl->psd[state].entry_lat) +
- + le32_to_cpu(ctrl->psd[state].exit_lat);
- if (total_latency_us > ctrl->ps_max_latency_us)
+ exit_latency_us =
+ (u64)le32_to_cpu(ctrl->psd[state].exit_lat);
+ if (exit_latency_us > ctrl->ps_max_latency_us)
continue;
+ total_latency_us =
+ exit_latency_us +
+ le32_to_cpu(ctrl->psd[state].entry_lat);
+
/*
* This state is good. Use it as the APST idle
* target for higher power states.
@@ -2438,6 +2441,10 @@
struct nvme_ns *ns;
mutex_lock(&ctrl->namespaces_mutex);
+
+ /* Forcibly start all queues to avoid having stuck requests */
+ blk_mq_start_hw_queues(ctrl->admin_q);
+
list_for_each_entry(ns, &ctrl->namespaces, list) {
/*
* Revalidating a dead namespace sets capacity to 0. This will
diff --git a/drivers/nvme/host/fc.c b/drivers/nvme/host/fc.c
index 5b14cbe..92964ce 100644
--- a/drivers/nvme/host/fc.c
+++ b/drivers/nvme/host/fc.c
@@ -1139,6 +1139,7 @@
/* *********************** NVME Ctrl Routines **************************** */
static void __nvme_fc_final_op_cleanup(struct request *rq);
+static void nvme_fc_error_recovery(struct nvme_fc_ctrl *ctrl, char *errmsg);
static int
nvme_fc_reinit_request(void *data, struct request *rq)
@@ -1265,7 +1266,7 @@
struct nvme_command *sqe = &op->cmd_iu.sqe;
__le16 status = cpu_to_le16(NVME_SC_SUCCESS << 1);
union nvme_result result;
- bool complete_rq;
+ bool complete_rq, terminate_assoc = true;
/*
* WARNING:
@@ -1294,6 +1295,14 @@
* fabricate a CQE, the following fields will not be set as they
* are not referenced:
* cqe.sqid, cqe.sqhd, cqe.command_id
+ *
+ * Failure or error of an individual i/o, in a transport
+ * detected fashion unrelated to the nvme completion status,
+ * potentially cause the initiator and target sides to get out
+ * of sync on SQ head/tail (aka outstanding io count allowed).
+ * Per FC-NVME spec, failure of an individual command requires
+ * the connection to be terminated, which in turn requires the
+ * association to be terminated.
*/
fc_dma_sync_single_for_cpu(ctrl->lport->dev, op->fcp_req.rspdma,
@@ -1359,6 +1368,8 @@
goto done;
}
+ terminate_assoc = false;
+
done:
if (op->flags & FCOP_FLAGS_AEN) {
nvme_complete_async_event(&queue->ctrl->ctrl, status, &result);
@@ -1366,7 +1377,7 @@
atomic_set(&op->state, FCPOP_STATE_IDLE);
op->flags = FCOP_FLAGS_AEN; /* clear other flags */
nvme_fc_ctrl_put(ctrl);
- return;
+ goto check_error;
}
complete_rq = __nvme_fc_fcpop_chk_teardowns(ctrl, op);
@@ -1379,6 +1390,10 @@
nvme_end_request(rq, status, result);
} else
__nvme_fc_final_op_cleanup(rq);
+
+check_error:
+ if (terminate_assoc)
+ nvme_fc_error_recovery(ctrl, "transport detected io error");
}
static int
@@ -2791,6 +2806,7 @@
ctrl->ctrl.opts = NULL;
/* initiate nvme ctrl ref counting teardown */
nvme_uninit_ctrl(&ctrl->ctrl);
+ nvme_put_ctrl(&ctrl->ctrl);
/* as we're past the point where we transition to the ref
* counting teardown path, if we return a bad pointer here,
diff --git a/drivers/nvme/host/pci.c b/drivers/nvme/host/pci.c
index d52701df..951042a 100644
--- a/drivers/nvme/host/pci.c
+++ b/drivers/nvme/host/pci.c
@@ -1367,7 +1367,7 @@
bool nssro = dev->subsystem && (csts & NVME_CSTS_NSSRO);
/* If there is a reset ongoing, we shouldn't reset again. */
- if (work_busy(&dev->reset_work))
+ if (dev->ctrl.state == NVME_CTRL_RESETTING)
return false;
/* We shouldn't reset unless the controller is on fatal error state
@@ -1903,7 +1903,7 @@
bool was_suspend = !!(dev->ctrl.ctrl_config & NVME_CC_SHN_NORMAL);
int result = -ENODEV;
- if (WARN_ON(dev->ctrl.state == NVME_CTRL_RESETTING))
+ if (WARN_ON(dev->ctrl.state != NVME_CTRL_RESETTING))
goto out;
/*
@@ -1913,9 +1913,6 @@
if (dev->ctrl.ctrl_config & NVME_CC_ENABLE)
nvme_dev_disable(dev, false);
- if (!nvme_change_ctrl_state(&dev->ctrl, NVME_CTRL_RESETTING))
- goto out;
-
result = nvme_pci_enable(dev);
if (result)
goto out;
@@ -2009,8 +2006,8 @@
{
if (!dev->ctrl.admin_q || blk_queue_dying(dev->ctrl.admin_q))
return -ENODEV;
- if (work_busy(&dev->reset_work))
- return -ENODEV;
+ if (!nvme_change_ctrl_state(&dev->ctrl, NVME_CTRL_RESETTING))
+ return -EBUSY;
if (!queue_work(nvme_workq, &dev->reset_work))
return -EBUSY;
return 0;
@@ -2136,6 +2133,7 @@
if (result)
goto release_pools;
+ nvme_change_ctrl_state(&dev->ctrl, NVME_CTRL_RESETTING);
dev_info(dev->ctrl.device, "pci function %s\n", dev_name(&pdev->dev));
queue_work(nvme_workq, &dev->reset_work);
@@ -2179,6 +2177,7 @@
nvme_change_ctrl_state(&dev->ctrl, NVME_CTRL_DELETING);
+ cancel_work_sync(&dev->reset_work);
pci_set_drvdata(pdev, NULL);
if (!pci_device_is_present(pdev)) {
diff --git a/drivers/nvme/host/rdma.c b/drivers/nvme/host/rdma.c
index 28bd255..24397d3 100644
--- a/drivers/nvme/host/rdma.c
+++ b/drivers/nvme/host/rdma.c
@@ -753,28 +753,26 @@
if (ret)
goto requeue;
- blk_mq_start_stopped_hw_queues(ctrl->ctrl.admin_q, true);
-
ret = nvmf_connect_admin_queue(&ctrl->ctrl);
if (ret)
- goto stop_admin_q;
+ goto requeue;
set_bit(NVME_RDMA_Q_LIVE, &ctrl->queues[0].flags);
ret = nvme_enable_ctrl(&ctrl->ctrl, ctrl->cap);
if (ret)
- goto stop_admin_q;
+ goto requeue;
nvme_start_keep_alive(&ctrl->ctrl);
if (ctrl->queue_count > 1) {
ret = nvme_rdma_init_io_queues(ctrl);
if (ret)
- goto stop_admin_q;
+ goto requeue;
ret = nvme_rdma_connect_io_queues(ctrl);
if (ret)
- goto stop_admin_q;
+ goto requeue;
}
changed = nvme_change_ctrl_state(&ctrl->ctrl, NVME_CTRL_LIVE);
@@ -782,7 +780,6 @@
ctrl->ctrl.opts->nr_reconnects = 0;
if (ctrl->queue_count > 1) {
- nvme_start_queues(&ctrl->ctrl);
nvme_queue_scan(&ctrl->ctrl);
nvme_queue_async_events(&ctrl->ctrl);
}
@@ -791,8 +788,6 @@
return;
-stop_admin_q:
- blk_mq_stop_hw_queues(ctrl->ctrl.admin_q);
requeue:
dev_info(ctrl->ctrl.device, "Failed reconnect attempt %d\n",
ctrl->ctrl.opts->nr_reconnects);
@@ -823,6 +818,13 @@
blk_mq_tagset_busy_iter(&ctrl->admin_tag_set,
nvme_cancel_request, &ctrl->ctrl);
+ /*
+ * queues are not a live anymore, so restart the queues to fail fast
+ * new IO
+ */
+ blk_mq_start_stopped_hw_queues(ctrl->ctrl.admin_q, true);
+ nvme_start_queues(&ctrl->ctrl);
+
nvme_rdma_reconnect_or_remove(ctrl);
}
@@ -1433,7 +1435,7 @@
/*
* We cannot accept any other command until the Connect command has completed.
*/
-static inline bool nvme_rdma_queue_is_ready(struct nvme_rdma_queue *queue,
+static inline int nvme_rdma_queue_is_ready(struct nvme_rdma_queue *queue,
struct request *rq)
{
if (unlikely(!test_bit(NVME_RDMA_Q_LIVE, &queue->flags))) {
@@ -1441,11 +1443,22 @@
if (!blk_rq_is_passthrough(rq) ||
cmd->common.opcode != nvme_fabrics_command ||
- cmd->fabrics.fctype != nvme_fabrics_type_connect)
- return false;
+ cmd->fabrics.fctype != nvme_fabrics_type_connect) {
+ /*
+ * reconnecting state means transport disruption, which
+ * can take a long time and even might fail permanently,
+ * so we can't let incoming I/O be requeued forever.
+ * fail it fast to allow upper layers a chance to
+ * failover.
+ */
+ if (queue->ctrl->ctrl.state == NVME_CTRL_RECONNECTING)
+ return -EIO;
+ else
+ return -EAGAIN;
+ }
}
- return true;
+ return 0;
}
static int nvme_rdma_queue_rq(struct blk_mq_hw_ctx *hctx,
@@ -1463,8 +1476,9 @@
WARN_ON_ONCE(rq->tag < 0);
- if (!nvme_rdma_queue_is_ready(queue, rq))
- return BLK_MQ_RQ_QUEUE_BUSY;
+ ret = nvme_rdma_queue_is_ready(queue, rq);
+ if (unlikely(ret))
+ goto err;
dev = queue->device->dev;
ib_dma_sync_single_for_cpu(dev, sqe->dma,