ARM: shmobile: mackerel: Register IRQ pinctrl mapping for SDHI0
Replace the GPIO-based SDHI0 IRQ pinmux configuration by a pinctrl
mapping.
Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>
diff --git a/arch/arm/mach-shmobile/board-mackerel.c b/arch/arm/mach-shmobile/board-mackerel.c
index bd3666b..4be236d 100644
--- a/arch/arm/mach-shmobile/board-mackerel.c
+++ b/arch/arm/mach-shmobile/board-mackerel.c
@@ -1359,6 +1359,8 @@
"sdhi0_ctrl", "sdhi0"),
PIN_MAP_MUX_GROUP_DEFAULT("sh_mobile_sdhi.0", "pfc-sh7372",
"sdhi0_wp", "sdhi0"),
+ PIN_MAP_MUX_GROUP_DEFAULT("sh_mobile_sdhi.0", "pfc-sh7372",
+ "intc_irq26_1", "intc"),
/* SDHI1 */
#if !IS_ENABLED(CONFIG_MMC_SH_MMCIF)
PIN_MAP_MUX_GROUP_DEFAULT("sh_mobile_sdhi.1", "pfc-sh7372",
@@ -1469,9 +1471,6 @@
/* Accelerometer */
irq_set_irq_type(IRQ21, IRQ_TYPE_LEVEL_HIGH);
- /* SDHI0 PORT172 card-detect IRQ26 */
- gpio_request(GPIO_FN_IRQ26_172, NULL);
-
/* Reset HDMI, must be held at least one EXTALR (32768Hz) period */
srcr4 = __raw_readl(SRCR4);
__raw_writel(srcr4 | (1 << 13), SRCR4);