can: janz-ican3: fix error and byte counters
The error and byte counter statistics were being incremented
incorrectly. For example, a TX error would be counted both in tx_errors
and rx_errors.
This corrects the problem so that tx_errors and rx_errors are only
incremented for errors caused by packets sent to the bus. Error packets
generated by the driver are not counted.
The byte counters are only increased for packets which are actually
transmitted or received from the bus. Error packets generated by the
driver are not counted.
Signed-off-by: Ira W. Snyder <iws@ovro.caltech.edu>
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
diff --git a/drivers/net/can/janz-ican3.c b/drivers/net/can/janz-ican3.c
index b19aca5..4a5a8fb 100644
--- a/drivers/net/can/janz-ican3.c
+++ b/drivers/net/can/janz-ican3.c
@@ -907,8 +907,8 @@
if (skb) {
cf->can_id |= CAN_ERR_CRTL;
cf->data[1] = CAN_ERR_CRTL_RX_OVERFLOW;
+ stats->rx_over_errors++;
stats->rx_errors++;
- stats->rx_bytes += cf->can_dlc;
netif_rx(skb);
}
}
@@ -982,7 +982,6 @@
dev_dbg(mod->dev, "bus error interrupt\n");
mod->can.can_stats.bus_error++;
- stats->rx_errors++;
cf->can_id |= CAN_ERR_PROT | CAN_ERR_BUSERROR;
switch (ecc & ECC_MASK) {
@@ -1001,8 +1000,12 @@
break;
}
- if ((ecc & ECC_DIR) == 0)
+ if (!(ecc & ECC_DIR)) {
cf->data[2] |= CAN_ERR_PROT_TX;
+ stats->tx_errors++;
+ } else {
+ stats->rx_errors++;
+ }
cf->data[6] = txerr;
cf->data[7] = rxerr;
@@ -1028,8 +1031,6 @@
}
mod->can.state = state;
- stats->rx_errors++;
- stats->rx_bytes += cf->can_dlc;
netif_rx(skb);
return 0;
}