usb: chipidea: host: vbus control change for OTG HNP
Leave vbus on/off hanlded by OTG fsm if in OTG mode.
Signed-off-by: Peter Chen <peter.chen@freescale.com>
Signed-off-by: Li Jun <b47624@freescale.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/chipidea/host.c b/drivers/usb/chipidea/host.c
index a8ac6c1..ffb4168 100644
--- a/drivers/usb/chipidea/host.c
+++ b/drivers/usb/chipidea/host.c
@@ -67,7 +67,11 @@
ehci->has_tdi_phy_lpm = ci->hw_bank.lpm;
ehci->imx28_write_fix = ci->imx28_write_fix;
- if (ci->platdata->reg_vbus) {
+ /*
+ * vbus is always on if host is not in OTG FSM mode,
+ * otherwise should be controlled by OTG FSM
+ */
+ if (ci->platdata->reg_vbus && !ci_otg_is_fsm_mode(ci)) {
ret = regulator_enable(ci->platdata->reg_vbus);
if (ret) {
dev_err(ci->dev,
@@ -89,7 +93,7 @@
return ret;
disable_reg:
- if (ci->platdata->reg_vbus)
+ if (ci->platdata->reg_vbus && !ci_otg_is_fsm_mode(ci))
regulator_disable(ci->platdata->reg_vbus);
put_hcd:
@@ -105,7 +109,7 @@
if (hcd) {
usb_remove_hcd(hcd);
usb_put_hcd(hcd);
- if (ci->platdata->reg_vbus)
+ if (ci->platdata->reg_vbus && !ci_otg_is_fsm_mode(ci))
regulator_disable(ci->platdata->reg_vbus);
}
}