ARM: at91/ohci: use gpio_is_valid to check the gpio
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/drivers/usb/host/ohci-at91.c b/drivers/usb/host/ohci-at91.c
index 95a9fec..5df0b0e 100644
--- a/drivers/usb/host/ohci-at91.c
+++ b/drivers/usb/host/ohci-at91.c
@@ -223,7 +223,7 @@
if (port < 0 || port >= 2)
return;
- if (pdata->vbus_pin[port] <= 0)
+ if (!gpio_is_valid(pdata->vbus_pin[port]))
return;
gpio_set_value(pdata->vbus_pin[port], !pdata->vbus_pin_inverted ^ enable);
@@ -234,7 +234,7 @@
if (port < 0 || port >= 2)
return -EINVAL;
- if (pdata->vbus_pin[port] <= 0)
+ if (!gpio_is_valid(pdata->vbus_pin[port]))
return -EINVAL;
return gpio_get_value(pdata->vbus_pin[port]) ^ !pdata->vbus_pin_inverted;
@@ -465,7 +465,7 @@
if (pdata) {
for (i = 0; i < ARRAY_SIZE(pdata->vbus_pin); i++) {
- if (pdata->vbus_pin[i] <= 0)
+ if (!gpio_is_valid(pdata->vbus_pin[i]))
continue;
gpio_request(pdata->vbus_pin[i], "ohci_vbus");
ohci_at91_usb_set_power(pdata, i, 1);
@@ -474,7 +474,7 @@
for (i = 0; i < ARRAY_SIZE(pdata->overcurrent_pin); i++) {
int ret;
- if (pdata->overcurrent_pin[i] <= 0)
+ if (!gpio_is_valid(pdata->overcurrent_pin[i]))
continue;
gpio_request(pdata->overcurrent_pin[i], "ohci_overcurrent");
@@ -499,14 +499,14 @@
if (pdata) {
for (i = 0; i < ARRAY_SIZE(pdata->vbus_pin); i++) {
- if (pdata->vbus_pin[i] <= 0)
+ if (!gpio_is_valid(pdata->vbus_pin[i]))
continue;
ohci_at91_usb_set_power(pdata, i, 0);
gpio_free(pdata->vbus_pin[i]);
}
for (i = 0; i < ARRAY_SIZE(pdata->overcurrent_pin); i++) {
- if (pdata->overcurrent_pin[i] <= 0)
+ if (!gpio_is_valid(pdata->overcurrent_pin[i]))
continue;
free_irq(gpio_to_irq(pdata->overcurrent_pin[i]), pdev);
gpio_free(pdata->overcurrent_pin[i]);