omap2+: Allow hwmod state changes to mux pads based on the state changes
Allow hwmod state changes to mux pads based on the state changes.
By default, only enable and disable the pads. In some rare cases
dynamic remuxing for the idles states is needed, this can be done
by passing the enable, idle, and off pads from board-*.c file along
with OMAP_DEVICE_PAD_REMUX flag.
Thanks to Paul Walmsley <paul@booyaka.com> for the comments on the
hwmod related changes.
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/omap_hwmod.c b/arch/arm/mach-omap2/omap_hwmod.c
index 77a8be6..e282e35 100644
--- a/arch/arm/mach-omap2/omap_hwmod.c
+++ b/arch/arm/mach-omap2/omap_hwmod.c
@@ -116,7 +116,6 @@
* - Open Core Protocol Specification 2.2
*
* To do:
- * - pin mux handling
* - handle IO mapping
* - bus throughput & module latency measurement code
*
@@ -149,6 +148,7 @@
#include "cm44xx.h"
#include "prm2xxx_3xxx.h"
#include "prm44xx.h"
+#include "mux.h"
/* Maximum microseconds to wait for OMAP module to softreset */
#define MAX_MODULE_SOFTRESET_WAIT 10000
@@ -1229,7 +1229,9 @@
oh->_state == _HWMOD_STATE_DISABLED) && oh->rst_lines_cnt == 1)
_deassert_hardreset(oh, oh->rst_lines[0].name);
- /* XXX mux balls */
+ /* Mux pins for device runtime if populated */
+ if (oh->mux)
+ omap_hwmod_mux(oh->mux, _HWMOD_STATE_ENABLED);
_add_initiator_dep(oh, mpu_oh);
_enable_clocks(oh);
@@ -1276,6 +1278,10 @@
_del_initiator_dep(oh, mpu_oh);
_disable_clocks(oh);
+ /* Mux pins for device idle if populated */
+ if (oh->mux)
+ omap_hwmod_mux(oh->mux, _HWMOD_STATE_IDLE);
+
oh->_state = _HWMOD_STATE_IDLE;
return 0;
@@ -1334,7 +1340,9 @@
}
/* XXX Should this code also force-disable the optional clocks? */
- /* XXX mux any associated balls to safe mode */
+ /* Mux pins to safe mode or use populated off mode values */
+ if (oh->mux)
+ omap_hwmod_mux(oh->mux, _HWMOD_STATE_DISABLED);
oh->_state = _HWMOD_STATE_DISABLED;