spidernet: enable support for bcm5461 ethernet phy
A newer board revision changed the type of ethernet phy.
Moreover, this generalizes the way that a phy gets switched
into fiber mode when autodetection is not available.
Signed-off-by: Jens Osterkamp <Jens.Osterkamp@de.ibm.com>
Signed-off-by: Arnd Bergmann <arnd.bergmann@de.ibm.com>
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
diff --git a/drivers/net/spider_net.c b/drivers/net/spider_net.c
index b36838b..394339d 100644
--- a/drivers/net/spider_net.c
+++ b/drivers/net/spider_net.c
@@ -1794,15 +1794,7 @@
if (phy->def->ops->setup_forced)
phy->def->ops->setup_forced(phy, SPEED_1000, DUPLEX_FULL);
- /* the following two writes could be moved to sungem_phy.c */
- /* enable fiber mode */
- spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x9020);
- /* LEDs active in both modes, autosense prio = fiber */
- spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x945f);
-
- /* switch off fibre autoneg */
- spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0xfc01);
- spider_net_write_phy(card->netdev, 1, 0x0b, 0x0004);
+ phy->def->ops->enable_fiber(phy);
phy->def->ops->read_link(phy);
pr_info("Found %s with %i Mbps, %s-duplex.\n", phy->def->name,