net: use core MTU range checking in core net infra
geneve:
- Merge __geneve_change_mtu back into geneve_change_mtu, set max_mtu
- This one isn't quite as straight-forward as others, could use some
closer inspection and testing
macvlan:
- set min/max_mtu
tun:
- set min/max_mtu, remove tun_net_change_mtu
vxlan:
- Merge __vxlan_change_mtu back into vxlan_change_mtu
- Set max_mtu to IP_MAX_MTU and retain dynamic MTU range checks in
change_mtu function
- This one is also not as straight-forward and could use closer inspection
and testing from vxlan folks
bridge:
- set max_mtu of IP_MAX_MTU and retain dynamic MTU range checks in
change_mtu function
openvswitch:
- set min/max_mtu, remove internal_dev_change_mtu
- note: max_mtu wasn't checked previously, it's been set to 65535, which
is the largest possible size supported
sch_teql:
- set min/max_mtu (note: max_mtu previously unchecked, used max of 65535)
macsec:
- min_mtu = 0, max_mtu = 65535
macvlan:
- min_mtu = 0, max_mtu = 65535
ntb_netdev:
- min_mtu = 0, max_mtu = 65535
veth:
- min_mtu = 68, max_mtu = 65535
8021q:
- min_mtu = 0, max_mtu = 65535
CC: netdev@vger.kernel.org
CC: Nicolas Dichtel <nicolas.dichtel@6wind.com>
CC: Hannes Frederic Sowa <hannes@stressinduktion.org>
CC: Tom Herbert <tom@herbertland.com>
CC: Daniel Borkmann <daniel@iogearbox.net>
CC: Alexander Duyck <alexander.h.duyck@intel.com>
CC: Paolo Abeni <pabeni@redhat.com>
CC: Jiri Benc <jbenc@redhat.com>
CC: WANG Cong <xiyou.wangcong@gmail.com>
CC: Roopa Prabhu <roopa@cumulusnetworks.com>
CC: Pravin B Shelar <pshelar@ovn.org>
CC: Sabrina Dubroca <sd@queasysnail.net>
CC: Patrick McHardy <kaber@trash.net>
CC: Stephen Hemminger <stephen@networkplumber.org>
CC: Pravin Shelar <pshelar@nicira.com>
CC: Maxim Krasnyansky <maxk@qti.qualcomm.com>
Signed-off-by: Jarod Wilson <jarod@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/macvlan.c b/drivers/net/macvlan.c
index 3234fcd..a064415 100644
--- a/drivers/net/macvlan.c
+++ b/drivers/net/macvlan.c
@@ -777,7 +777,7 @@
{
struct macvlan_dev *vlan = netdev_priv(dev);
- if (new_mtu < 68 || vlan->lowerdev->mtu < new_mtu)
+ if (vlan->lowerdev->mtu < new_mtu)
return -EINVAL;
dev->mtu = new_mtu;
return 0;
@@ -1085,6 +1085,8 @@
{
ether_setup(dev);
+ dev->min_mtu = 0;
+ dev->max_mtu = ETH_MAX_MTU;
dev->priv_flags &= ~IFF_TX_SKB_SHARING;
netif_keep_dst(dev);
dev->priv_flags |= IFF_UNICAST_FLT;
@@ -1297,6 +1299,10 @@
else if (dev->mtu > lowerdev->mtu)
return -EINVAL;
+ /* MTU range: 68 - lowerdev->max_mtu */
+ dev->min_mtu = ETH_MIN_MTU;
+ dev->max_mtu = lowerdev->max_mtu;
+
if (!tb[IFLA_ADDRESS])
eth_hw_addr_random(dev);