e1000e: flow control doesn't re-enable
When changing flow control (pause) parameters, the flow control thresholds
(i.e. when to send XON/XOFF frames) may not be setup correctly on parts
with copper media. Call the existing e1000_set_fc_watermarks()
function to set these thresholds.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/e1000e/ethtool.c b/drivers/net/e1000e/ethtool.c
index a70999b..0364b91 100644
--- a/drivers/net/e1000e/ethtool.c
+++ b/drivers/net/e1000e/ethtool.c
@@ -335,10 +335,18 @@
hw->fc.current_mode = hw->fc.requested_mode;
- retval = ((hw->phy.media_type == e1000_media_type_fiber) ?
- hw->mac.ops.setup_link(hw) : e1000e_force_mac_fc(hw));
+ if (hw->phy.media_type == e1000_media_type_fiber) {
+ retval = hw->mac.ops.setup_link(hw);
+ /* implicit goto out */
+ } else {
+ retval = e1000e_force_mac_fc(hw);
+ if (retval)
+ goto out;
+ e1000e_set_fc_watermarks(hw);
+ }
}
+out:
clear_bit(__E1000_RESETTING, &adapter->state);
return retval;
}