i2c: Bus drivers return -Errno not -1
Tighten error paths used by various i2c adapters (mostly x86) so
they return real fault/errno codes instead of a "-1" (which is
most often interpreted as "-EPERM"). Build tested, with eyeball
review.
One minor initial goal is to have adapters consistently return
the code "-ENXIO" when addressing a device doesn't get an ACK
response, at least in the probe paths where they are already
good at stifling related logspam.
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Jean Delvare <khali@linux-fr.org>
diff --git a/drivers/i2c/busses/i2c-sis96x.c b/drivers/i2c/busses/i2c-sis96x.c
index dc235bb..29757b2 100644
--- a/drivers/i2c/busses/i2c-sis96x.c
+++ b/drivers/i2c/busses/i2c-sis96x.c
@@ -111,7 +111,7 @@
/* check it again */
if (((temp = sis96x_read(SMB_CNT)) & 0x03) != 0x00) {
dev_dbg(&sis96x_adapter.dev, "Failed (0x%02x)\n", temp);
- return -1;
+ return -EBUSY;
} else {
dev_dbg(&sis96x_adapter.dev, "Successful\n");
}
@@ -136,19 +136,19 @@
/* If the SMBus is still busy, we give up */
if (timeout >= MAX_TIMEOUT) {
dev_dbg(&sis96x_adapter.dev, "SMBus Timeout! (0x%02x)\n", temp);
- result = -1;
+ result = -ETIMEDOUT;
}
/* device error - probably missing ACK */
if (temp & 0x02) {
dev_dbg(&sis96x_adapter.dev, "Failed bus transaction!\n");
- result = -1;
+ result = -ENXIO;
}
/* bus collision */
if (temp & 0x04) {
dev_dbg(&sis96x_adapter.dev, "Bus collision!\n");
- result = -1;
+ result = -EIO;
}
/* Finish up by resetting the bus */
@@ -161,11 +161,12 @@
return result;
}
-/* Return -1 on error. */
+/* Return negative errno on error. */
static s32 sis96x_access(struct i2c_adapter * adap, u16 addr,
unsigned short flags, char read_write,
u8 command, int size, union i2c_smbus_data * data)
{
+ int status;
switch (size) {
case I2C_SMBUS_QUICK:
@@ -203,17 +204,17 @@
case I2C_SMBUS_BLOCK_DATA:
/* TO DO: */
dev_info(&adap->dev, "SMBus block not implemented!\n");
- return -1;
+ return -EOPNOTSUPP;
break;
default:
- dev_info(&adap->dev, "Unsupported I2C size\n");
- return -1;
- break;
+ dev_info(&adap->dev, "Unsupported SMBus operation\n");
+ return -EOPNOTSUPP;
}
- if (sis96x_transaction(size))
- return -1;
+ status = sis96x_transaction(size);
+ if (status)
+ return status;
if ((size != SIS96x_PROC_CALL) &&
((read_write == I2C_SMBUS_WRITE) || (size == SIS96x_QUICK)))