spi/spi-atmel: add support transfer on CS1,2,3, not only on CS0
Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
index af3dbab..26c126b 100644
--- a/drivers/spi/spi-atmel.c
+++ b/drivers/spi/spi-atmel.c
@@ -255,11 +255,6 @@
* Master on Chip Select 0.") No workaround exists for that ... so for
* nCS0 on that chip, we (a) don't use the GPIO, (b) can't support CS_HIGH,
* and (c) will trigger that first erratum in some cases.
- *
- * TODO: Test if the atmel_spi_is_v2() branch below works on
- * AT91RM9200 if we use some other register than CSR0. However, don't
- * do this unconditionally since AP7000 has an errata where the BITS
- * field in CSR0 overrides all other CSRs.
*/
static void cs_activate(struct atmel_spi *as, struct spi_device *spi)
@@ -269,18 +264,22 @@
u32 mr;
if (atmel_spi_is_v2(as)) {
- /*
- * Always use CSR0. This ensures that the clock
- * switches to the correct idle polarity before we
- * toggle the CS.
+ spi_writel(as, CSR0 + 4 * spi->chip_select, asd->csr);
+ /* For the low SPI version, there is a issue that PDC transfer
+ * on CS1,2,3 needs SPI_CSR0.BITS config as SPI_CSR1,2,3.BITS
*/
spi_writel(as, CSR0, asd->csr);
if (as->caps.has_wdrbt) {
- spi_writel(as, MR, SPI_BF(PCS, 0x0e) | SPI_BIT(WDRBT)
- | SPI_BIT(MODFDIS) | SPI_BIT(MSTR));
+ spi_writel(as, MR,
+ SPI_BF(PCS, ~(0x01 << spi->chip_select))
+ | SPI_BIT(WDRBT)
+ | SPI_BIT(MODFDIS)
+ | SPI_BIT(MSTR));
} else {
- spi_writel(as, MR, SPI_BF(PCS, 0x0e) | SPI_BIT(MODFDIS)
- | SPI_BIT(MSTR));
+ spi_writel(as, MR,
+ SPI_BF(PCS, ~(0x01 << spi->chip_select))
+ | SPI_BIT(MODFDIS)
+ | SPI_BIT(MSTR));
}
mr = spi_readl(as, MR);
gpio_set_value(asd->npcs_pin, active);